Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Performance
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Tuners sell upgrades in "stages", but there is no standard definition. The meaning varies from car to car and engine to engine, with some brands using 1, 1+ and 2, others 1 to 3, and some going to 5 (8020 Automotive). This page describes the common pattern and the questions to ask before buying a package. The gain figures here are one retailer's ranges, not results for any given car.

The common pattern

  • Stage 1. A calibration change for an essentially standard car. Typical ranges quoted are about 5 to 20 hp for naturally aspirated engines and often 20 to 50 or more for turbocharged ones, with an intake, cat-back exhaust or blow-off valve as the usual supporting parts. It assumes a healthy, well-maintained, standard vehicle, and allows only very minor changes such as a filter that does not significantly alter airflow (CSC Motors).
  • Stage 2. A calibration matched to bolt-on hardware that helps the engine breathe: typically an upgraded intake and a performance exhaust. Headers on a naturally aspirated engine or downpipes on a turbo engine are common additions, with an uprated front intercooler as a common cooling upgrade. A "Stage 2+" may need camshafts or pulleys and a higher octane or ethanol fuel.
  • Stage 3 and above. Major hardware: a larger turbo or supercharger, extensive fuel system upgrades and often strengthened internals such as rods, pistons, bearings and head studs, plus brakes, suspension, differential, tyres and cooling. It is often suited to track use.

The two sources agree on the shape and differ on detail, which is the point: check what a specific tuner's package contains and what parts it assumes.

What changes as the stage rises

The common thread is that every added unit of output adds a demand elsewhere. In this wiki's pages the demands map out like this:

Generic and bespoke tunes

A generic tune is a pre-made file for a range of vehicles of the same make, model and engine. It does not account for the car's condition, mileage, modifications or the fuel quality and altitude it will see. A bespoke tune involves reading the ECU, a diagnostic health check, data logging, tailored calibration and dyno testing (CSC Motors). A higher stage on a generic file leaves more of the risk with the owner. See how an ECU is remapped and common misconceptions about remapping.

Questions to ask before buying

  1. What exactly is included in this stage, and which parts must already be fitted? Which supporting parts are assumed but not sold?
  2. Is the file generic or built for this car, and is it checked on a dyno or a road log?
  3. What does the package assume about fuel, and what happens if the car is run on a lower grade?
  4. What condition checks come first: compression, leaks, boost, fuel pressure, codes?
  5. Which parts of the car limit at this level: clutch, tyres, cooling, brakes?
  6. Is the package legal for the intended use? Some packages include options, such as removing a diesel particulate filter, that are only lawful for off-road or motorsport use. Emissions equipment, insurance, warranty and roadworthiness rules vary by country, and neither source covers them, so ask the tuner and your insurer and check local law.

All engine modification and tuning is at the owner's risk. More power adds stress the engine may or may not tolerate, and a tuner's own recommendations should be followed over a generic parts list. Agree what will be measured and reported before the work starts, as set out under agreeing the work with a tuning provider on engine performance upgrades, and see planning a performance engine build for a planning order.

Sources