Ethanol blends are used in performance engines because they resist knock and cool the charge, but they change the fuel mass, the cold-start behaviour and the materials the fuel touches. This page gives the general picture. Fuel system upgrades covers the pumps and injectors, and Simos 18 ethanol and flex fuel is a family-specific example.
What E85 is
In the US, E85 is defined by ASTM D5798 as a fuel with an ethanol content of 51 to 83 volume per cent, with vapour-pressure classes that vary by season. Ethanol content is lowered in colder months to raise vapour pressure for cold starts (US DOE Alternative Fuels Data Center). Flexible-fuel vehicles run on any ethanol-petrol blend, so the fuel in a tank can sit anywhere between petrol and the upper end of that range. That definition is a US specification and is not a specification for every market. Check the fuel actually sold locally, and treat the pump label as a nominal description, not a measurement.
What ethanol changes
- More fuel mass for the same air. The stoichiometric ratio is 9.0:1 for ethanol against 14.7:1 for petrol (Haltech flex-fuel guide), so an ethanol blend needs substantially more fuel mass for the same air mass. Injector flow, pump capacity and rail pressure must cover that, as set out on fuel system upgrades.
- Octane and knock. Octane rises with ethanol content, not in a straight line, and peaks near 60 per cent ethanol in Haltech's description, so ignition timing needs correcting. For what octane measures see fuel octane; for the knock limit see ignition tuning.
- Charge cooling. Ethanol cools the charge as it evaporates, which is part of why it helps knock-limited engines: see charge cooling.
- Cold starting. E85's seasonal ethanol content is tied to vapour pressure for cold starts. A tune that starts well in summer can start poorly in cold weather on the same blend. Expect cold-start and prime tables to need attention on an engine converted to run it.
- Exhaust flow. Boost duty may need adjusting at higher ethanol content because of the added exhaust volume. See electronic boost control.
- Materials. The fuel system must be compatible with the blend: pumps, lines, seals and rails. The DOE component guide describes the elements of an ethanol-compatible vehicle. Confirm each part's rating with its maker.
Fixed blend or flex fuel
An engine can be calibrated for one fixed blend, or fitted with a composition sensor so the ECU adjusts to whatever is in the tank. A typical sensor reports ethanol content and fuel temperature, which a supported ECU uses to blend fuel, ignition and other corrections between the petrol and E85 calibrations. The sensor alone does not configure or validate anything. Its position matters: mount it as close to the injectors as possible in the high-pressure feed where flow is not restricted. If it must go in the return line, limit sampling to low-flow conditions to reduce aeration errors.
Order of work
Haltech's guide for its own ECUs sets out a sequence that illustrates the general approach:
- Complete a full petrol tune first, with accurate injector data and the fuel, ignition, target lambda and boost tables set.
- Drain the fuel system, then refill with fresh E85.
- Add an E85 point on the flex axis of the relevant tables and tune with the blend fixed at that value.
- Add intermediate points, typically around 25 and 50 per cent, so the ECU's learning can fill in the detail as the blend changes over time.
Other ECUs use other table structures and terms, so this is an example, not a procedure for any given controller. Measure the result with a wideband sensor that is scaled for ethanol (see air-fuel ratio and wideband lambda sensors), and log knock correction and fuel pressure under load. A numeric AFR copied from a petrol tune is wrong for E85.
Sources
- Ethanol E85 specifications. US Department of Energy, Alternative Fuels Data Center. ASTM D5798 ethanol range, vapour-pressure classes and seasonal adjustment. Accessed 2026-11-19.
- Flex fuel tuning guide. Haltech support. Stoichiometry, octane, sensor placement, table expansion and tuning sequence for its ECUs. Accessed 2026-11-19.
- Ethanol component guide. US Department of Energy. Components of ethanol-compatible vehicles. Cited as in fuel system upgrades; not re-read for this page.