Tuning Wiki

An engine upgrade raises the force the driven wheels are asked to deliver. Whether the car gets quicker depends on how much force the tyres can carry, how the car's weight is shared between the axles, and how much mass has to be accelerated. This page covers those limits. The engine-side work is on engine performance upgrades.

The grip limit

The force a tyre can transmit is at most µW, where µ is the coefficient of adhesion and W is the load on the tyre. µ depends on the tyre compound, the road surface, temperature, humidity and other factors, and it varies slightly with load. Because the car's weight sets W, the maximum acceleration a tyre can sustain works out to µg, independent of the car's mass (Beckman: The Physics of Racing, Part 7). The limit on how hard a car can accelerate through its tyres comes from the grip, and adding power does not raise it. Once the tyres are at their limit, more power produces wheelspin, not more acceleration.

That is a simplified model with one friction coefficient. Real tyres also change grip with temperature and slip, and the wiki's tyre pages carry model-specific information: see the car tyres section.

Weight transfer under acceleration

Under acceleration load moves from the front wheels to the rear. The longitudinal transfer is ΔW = a·h·m / b, where a is the acceleration, h the height of the centre of mass, m the mass and b the wheelbase. It occurs even in a perfectly rigid car, and a lower centre of mass and a longer wheelbase both reduce it (Wikipedia: Weight transfer). The consequence is that front-wheel-drive cars lose traction on the driven axle as they accelerate, while rear-wheel-drive and rear-biased all-wheel-drive cars gain it. In every case the car's acceleration is limited by the grip available at the driven axle, including the weight transferred to it.

So the layout matters as much as the power figure. A high-power front-wheel-drive car is limited sooner than a rear-drive one, and a drivetrain that sends torque to all four wheels uses more of the available grip. See differentials, transfer boxes and ABS and traction control.

Where weight reduction helps

Below the grip limit, taking mass out raises acceleration for the same power, because the force the engine delivers acts on less mass. It also reduces the load the brakes and tyres carry. Weight is not purely an enemy of traction. Grip scales with the load on the tyre, so a lighter car carries less load but also needs less force to accelerate, which is why the limiting acceleration stays at µg. Tyre load sensitivity adds a caution: when load is shared unevenly between tyres, the total grip available falls slightly. That is part of why weight distribution, and not only total weight, matters.

This wiki does not give figures for specific weight savings. Measure the car's weight on corner scales before and after any change, and record the fuel and fluid levels.

Planning an upgrade around the limit

  • Know where the car is limited. If the tyres break traction in the first gears, more power mainly moves the problem to a different gear. Data logging with wheel speeds, where available, shows it: data logging for engine preparation and design.
  • Tyres first. A tyre with more grip raises the limit that power runs into. Match the tyre to the use; this is covered on the wiki's car tyres pages.
  • The drivetrain has to carry the torque. Clutches, gearboxes, differentials and driveshafts see more torque too: clutches, gearboxes and driveshafts.
  • Launch strategies. Electronic launch control limits torque or engine speed to keep the tyres at their grip limit: ME7 launch control, no-lift shift and anti-lag is one worked example.
  • Brakes and suspension. A car that accelerates harder also needs to stop and turn harder: brake fluid and fade and coilover setup cover part of it. Consult the component makers and a qualified workshop for the rest.

Sources