An intake-air temperature (IAT) sensor reports temperature at its installed location. The ECU may use that information in air-charge estimation, fuelling, ignition and protection strategies. A logged intake temperature is not necessarily the same as the temperature inside a cylinder or a separately modelled charge temperature. HELLA: intake-air temperature sensor
How it measures
Many IAT sensors use a negative-temperature-coefficient thermistor: resistance falls as the sensing element warms. The ECU interprets the circuit signal using a calibration for that sensor and input circuit. Resistance is not a universal linear number per degree; compare readings with the correct sensor's temperature curve. Some sensors are integrated into an airflow or pressure sensor rather than installed separately. HELLA: combined manifold-pressure and air-temperature sensor
Location and heat soak
A sensor measures the temperature of its own element, which is influenced by moving air and by heat conducted from its mount. After a hot soak, the reading can differ from the temperature of fresh air entering the engine; response also depends on airflow and sensor construction. In a forced-induction installation, the temperature before a compressor or intercooler is a different measurement from the temperature downstream. Identify the actual sensor location before comparing values or choosing corrections.
For its aftermarket installation, Haltech recommends a location representative of the air entering the engine and notes that manifold mounting can produce heat soak. Follow the specific ECU and vehicle guidance: changing the position changes what the ECU measures and may require calibration review. Haltech: inlet air temperature sensor location.
Diagnosis and calibration
- Record the symptom and fault codes. When the engine has been parked long enough to cool, compare the IAT reading with ambient and other relevant temperature readings; differences are clues, not a substitute for the specified test.
- Inspect the sensor, connector and harness. Consult the vehicle-specific circuit diagram and test procedures before checking supply, ground, signal or disconnected sensor resistance. Use the correct temperature-dependent reference values.
- Compare the sensor response with a suitable independent temperature measurement at the same location and under repeatable conditions. A slow or heat-soaked reading may be an installation effect; a genuine high charge temperature requires an air-system investigation.
- For a programmable ECU, select the exact sensor calibration and appropriate input and pull-up configuration. Where two controllers share a sensor, check their combined electrical loading rather than assuming the second connection is passive. Haltech: input and calibration options.
Related reading: Engine load sensing, Simos 18 intake-air temperature and charge modelling, and coolant temperature sensor diagnosis.
For air temperature sensor and circuit checks, see Intake air temperature sensor faults. See also Exhaust gas temperature sensor faults.