Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Diagnostics
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

An intake-air temperature (IAT) sensor reports temperature at its installed location. The ECU may use that information in air-charge estimation, fuelling, ignition and protection strategies. A logged intake temperature is not necessarily the same as the temperature inside a cylinder or a separately modelled charge temperature. HELLA: intake-air temperature sensor

How it measures

Many IAT sensors use a negative-temperature-coefficient thermistor: resistance falls as the sensing element warms. The ECU interprets the circuit signal using a calibration for that sensor and input circuit. Resistance is not a universal linear number per degree; compare readings with the correct sensor's temperature curve. Some sensors are integrated into an airflow or pressure sensor rather than installed separately. HELLA: combined manifold-pressure and air-temperature sensor

Location and heat soak

A sensor measures the temperature of its own element, which is influenced by moving air and by heat conducted from its mount. After a hot soak, the reading can differ from the temperature of fresh air entering the engine; response also depends on airflow and sensor construction. In a forced-induction installation, the temperature before a compressor or intercooler is a different measurement from the temperature downstream. Identify the actual sensor location before comparing values or choosing corrections.

For its aftermarket installation, Haltech recommends a location representative of the air entering the engine and notes that manifold mounting can produce heat soak. Follow the specific ECU and vehicle guidance: changing the position changes what the ECU measures and may require calibration review. Haltech: inlet air temperature sensor location.

Diagnosis and calibration

  1. Record the symptom and fault codes. When the engine has been parked long enough to cool, compare the IAT reading with ambient and other relevant temperature readings; differences are clues, not a substitute for the specified test.
  2. Inspect the sensor, connector and harness. Consult the vehicle-specific circuit diagram and test procedures before checking supply, ground, signal or disconnected sensor resistance. Use the correct temperature-dependent reference values.
  3. Compare the sensor response with a suitable independent temperature measurement at the same location and under repeatable conditions. A slow or heat-soaked reading may be an installation effect; a genuine high charge temperature requires an air-system investigation.
  4. For a programmable ECU, select the exact sensor calibration and appropriate input and pull-up configuration. Where two controllers share a sensor, check their combined electrical loading rather than assuming the second connection is passive. Haltech: input and calibration options.

Related reading: Engine load sensing, Simos 18 intake-air temperature and charge modelling, and coolant temperature sensor diagnosis.