Dynostar manufactures chassis dynamometers and associated data acquisition and control equipment. Its DAS electronics and Advanced Dyno Station software are supplied with Dynostar dynos, and the company advertises an A801 retrofit package for roller chassis installations. The mechanical dyno, retarder, power supply, sensors and control software must be specified as a complete system.

DAS and Advanced Dyno Station
Dynostar says its rolling-road chassis dynos use its DAS data-acquisition system. A junction box collects supported sensor signals such as boost, throttle position, temperature and air/fuel ratio. The Advanced Dyno Station PC software presents measurement screens, a run database and graphs. It displays and compares power and sensor traces using configured vehicle and test settings; the sensors, modules and licences included depend on the package.
The supplier describes Dynamic, Dynamic A/T, Static and Transient tests. In the stated Static mode the retarder holds selected points; Transient mode adjusts retarder load for a requested test duration. Those modes require a suitable braked dyno and correctly configured hardware, not software alone. Weather corrections, units and graph traces are configurable. Dynostar notes its EV mode requires the EV module; check actual software generation and options. Dynostar software documentation.
A801 upgrade kit
The DAS upgrade kit A801 is advertised for refurbishing roller chassis dynos. The listing identifies a DAS unit, junction box, remote, communication and RS232 cables, drum-speed sensor, load cell, eddy-current brake (ECB) power supply, calibration weight and brackets. It also describes facilities for programmed cycles and control of suitable fan, wheelbase and beam equipment. The product is not itself the roller frame or brake.
An ECB supply is a power interface for the brake: match the particular coil's voltage, current and cooling requirements, not just the controller plug. Confirm the roller/sensor layout and whether the existing power supply and wiring can be reused. The supplier calls the kit broadly applicable to roller chassis upgrades, but its listing does not establish compatibility with every named make, hydraulic valve or hub dyno. Discuss a specific installation before purchasing.
Other units and options
The Dynostar electronics catalogue separately lists Mini DAS A802, DAS Integrated A803 and an EV kit, alongside temperature and lambda modules. The catalogue listing alone does not establish that these alternatives have A801's full contents or supported layouts; obtain each kit's own specification.
For an example of manufacturer-supplied equipment, the Dynostar 2C product page lists integrated DAS, Advanced Dyno Station and a remote, while the 4T page identifies an eddy-current brake and the same software family. These are distinct dynos with their own capabilities and operating envelopes.
Installation and calibration
Record roller diameter and inertia, speed-sensor pulses, load-cell range, brake-supply rating, operating modes and correction standard. Verify sensor calibration, emergency-stop and actuator behaviour using the maker's procedures. A controller upgrade does not increase the retarder or roller's mechanical or thermal capacity. Product details are based on the cited manufacturer listings; verify current version and support.
Related: Dynamometer control systems · Factory and aftermarket controller comparison · Dyno measurement.