Wheels and tyres are the last link between an upgraded car and the road. They affect fitment, steering feel, bearing loads and how well the suspension keeps the tyre in contact with the road. This page covers wheel offset and unsprung mass. Tyre models are compared on the wiki's car tyres pages, and the grip limit is on power, weight and traction.
Wheel offset
Offset, shown as ET (from the German Einpresstiefe), is the distance in millimetres from the wheel's hub-mounting surface to its centreline. Positive offset moves the mounting surface toward the outer edge of the wheel, and negative offset moves it toward the inner edge (Wikipedia: Wheel offset).
Offset changes where the wheel sits relative to the arch and the suspension. Moving from +45 mm to +30 mm offset pushes the wheel outward by about 15 mm, which matters when only a small gap to the arch exists. Too much negative offset puts the wheel close to the arch edge, and too much positive offset puts the tyre close to the suspension components. Width, offset and tyre size together decide whether a combination fits, and brake caliper clearance has to be allowed for.
Steering and bearing effects
Offset changes the lever arm between the centre of the tyre contact and the steering axis, which alters how road irregularities, braking and acceleration forces become steering torque. That affects bump steer and torque steer, and it is part of the scrub radius, so the manufacturer's limits are the safe range. Moving the wheel centreline further from the bearing centreline also increases the loads on the wheel bearings (Wikipedia). A car with more power and grip loads the bearings and steering more, so these effects matter more after an upgrade.
Unsprung mass
Unsprung mass is the weight of the wheels, tyres, hubs, axles, brakes (if mounted at the wheel), and the parts of the springs, dampers and links that move with the wheel. Everything the body supports is sprung mass (Wikipedia: Unsprung mass).
- Grip. When a bump pushes the tyre up, the unsprung mass moves with it. Lighter wheels rebound more quickly, which keeps grip more consistent on rough surfaces, and lighter wheels are preferred on high-performance cars for that reason.
- Comfort. A lighter unsprung mass also absorbs less of the road's vibration, so more reaches the cabin as noise and harshness.
- Wheel control. Where the wheel is poorly located vertically, such as on a live axle on leaf springs, heavy unsprung mass combined with hard acceleration or braking can cause severe wheel hop, which hurts traction and steering control.
So a lighter wheel and tyre is useful, but it is one of several factors. A very lightweight wheel that is not strong enough, or that does not fit the hub and brakes, is not an upgrade. Use wheels that carry the correct load rating and fit for the vehicle, with the right centre bore, bolt pattern and nut seat, and use the wheel maker's torque and fitting instructions.
Choosing and checking
- Record the standard wheel size, offset and tyre size and weight before changing anything.
- Check the new offset against the arch and suspension clearance through the full steering lock and suspension travel, with the car at the lowest height you intend to run: coilover setup.
- Check the tyre's rolling circumference against the original, since a change affects the speedometer and gearing: gearing, final drive and road speed.
- Check brake clearance and that the wheel is rated for the vehicle's axle load and use.
- Have the wheel and tyre balanced and the alignment checked, then check for rubbing and vibration after the first drive.
Fitment rules for modified cars vary by country. Check the legal and insurance position with a qualified local provider.
Sources
- Wheel offset. Wikipedia. Definition, positive and negative offset, scrub radius and clearance. Accessed 2026-11-19.
- Unsprung mass. Wikipedia. Definition and effects on grip, comfort and wheel control. Accessed 2026-11-19.