Tuning Wiki

Gearing decides how engine speed turns into road speed, and so how much of the engine's torque band the car can use. This page gives the relationship, a worked example and the effects of changing the final drive or the tyres. How a gearbox works is on gearboxes overview, and the torque and traction limits that gearing runs into are on power, weight and traction.

The parts of the drivetrain ratio

The final drive is the last set of components that delivers torque to the drive wheels, and on a road vehicle it includes the differential. The engine and wheel speeds differ and have to be matched by the gear ratios, and the gearbox changes its ratio as the vehicle speed changes so the engine can stay in a suitable speed range (Wikipedia: Final drive). On many front-wheel-drive manual cars the gearbox and final drive share one housing. The overall ratio in any gear is the gearbox ratio multiplied by the final drive ratio. Where there is a transfer case or a primary drive, include its ratio too.

Road speed from engine speed

Vehicle speed is the tyre's rolling circumference multiplied by engine speed, divided by the overall ratio. The unit conversions give these working forms:

  • Metric: speed in km/h = rpm × rolling circumference in metres × 60 ÷ (overall ratio × 1,000).
  • Imperial, with the tyre diameter in inches: speed in mph = rpm × diameter × π ÷ (overall ratio × 1,056).

These are the standard forms used by gearing references such as Motofomo and YouCanic. Check any online calculator against one of them, because the unit constants are easy to get wrong.

The rolling circumference is smaller than the circumference of the unloaded tyre, since the loaded tyre flattens at the contact patch, and it changes slightly with load, pressure and speed. For a precise figure, measure it by rolling the car forward one wheel revolution.

Worked example

This is an illustrative calculation, not data for any car. Take a rolling circumference of 1.95 m and a gearbox ratio of 1.00 in the top gear used.

Final drive 3.90Final drive 4.20
Road speed at 3,000 rpm90.0 km/h83.6 km/h
Engine speed at 100 km/h3,333 rpm3,590 rpm

The shorter final drive (4.20) raises the engine speed at every road speed by 7.7 per cent, which is the ratio of the two final drives. Each gear takes the car to a lower top speed, and the engine sits higher in its rev range at a given speed.

What changing the ratio or the tyre does

  • A shorter (numerically higher) final drive multiplies torque at the wheels in every gear, which helps acceleration where traction allows, and raises the rpm at a given speed, which raises cruising noise and fuel use. Top speed in a given gear falls.
  • A taller final drive does the reverse: lower cruising rpm, less torque at the wheels.
  • A larger tyre diameter acts like a taller final drive: lower rpm at a given speed, and the speedometer reads low. A smaller diameter acts like a shorter one. Speedometer and odometer calibration then no longer match the road speed.
  • Limits. A shorter ratio does not help if the tyres are already at their grip limit in the first gears, and it can leave a top gear that the engine cannot pull at the speeds in use. Check that the rev limit and the power band at the top end still suit the car's use: valve springs, valve float and rev limits.

Checks

  1. Record the existing gear and final drive ratios, and the rolling circumference, before any change.
  2. Plot engine speed against road speed for each gear, and mark the engine's power and torque peaks and its rev limit. The gears should keep the engine in its useful range after each shift.
  3. After a ratio or tyre change, correct the speedometer calibration where the vehicle allows it, and check that stability and traction control inputs, which rely on wheel speed, still read correctly: ABS and traction control.
  4. Check that the clutch, driveshafts and differential cope with the new torque multiplication: differentials, driveshafts and clutches.

Sources