Tuning Wiki

Coilovers combine a spring and a damper in one adjustable unit. They change how the car sits and moves, which matters once more power and grip are added. This page covers the three adjustments most owners meet: ride height, preload and damping. It is a setup guide for common adjustable kits. Follow the maker's instructions for any particular coilover, because designs differ. For how weight transfers under power and braking see power, weight and traction, and for the roll-stiffness side of handling balance see anti-roll bars and handling balance.

Ride height is set at the body, not with preload

On adjustable-body coilovers, ride height is set by moving the shock body or lower mount, not by winding the spring perch. Using the perch to lower the car reduces suspension travel and spoils ride quality. Preload exists to keep the spring seated; it is not a height adjustment. A spring of a given rate does not set the height on its own either, since spring length and the position of the lower mount or body decide it (SPRINGRATES).

Measure from the wheel centre to the arch at all four corners and adjust in small steps, with the car on level ground and the tyres at the right pressure. The same source advises matching the height measurements and the damper settings on both sides of the car.

Preload

Preload is the amount the spring is compressed when the damper is fully extended. The aim is to take up the slack so the spring does not rattle, not to carry weight. A common instruction for body-adjustable kits is a gap of about 3 to 5 mm between the spring seat ring and the lock ring beneath it, set one corner at a time and kept even across all four corners (SPRINGRATES). Check the coilover maker's own figure first, because that is a general instruction for one style of kit.

Preload should not use up suspension travel. A car lowered until the bump stops carry the load has no useful travel left.

Damping

The damper controls how quickly the suspension compresses and rebounds. The adjuster is usually at the top of the strut: turning it clockwise stiffens the damping and anticlockwise softens it. Start in the middle of the range and adjust in small steps, with the same setting on both sides.

The spring rate and the damper must suit each other. A stiffer spring needs stiffer damping to control it, and the setting that feels best on the road is not necessarily the one that suits a track. The maker's recommended range for the spring supplied is the starting point.

Alignment afterwards

A change in ride height alters camber and toe, so the car needs a proper alignment after any height adjustment, or the tyres wear unevenly and the handling suffers (SPRINGRATES). Tyre choice and pressures are part of the same balance: see the car tyres section, and wheel size, offset and unsprung mass for fitment and clearance with a lowered car.

Checks

  1. Measure ride height at all four corners and record the settings, damper clicks and tyre pressures.
  2. Check that there is clear suspension travel and that nothing rubs: tyre against arch liner, brake lines at full droop, driveshaft angles.
  3. Re-torque fasteners and recheck height after the first drive, since new springs can settle.
  4. Have the alignment set, then change one setting at a time and note the effect.

This wiki covers anti-roll bars on their own page, but not bushes or geometry in any depth. Check legal and insurance requirements for a lowered car with a qualified local provider.

Sources