Tuning Wiki

Tyre pressure is the cheapest adjustment on a car and one that affects safety, wear, handling and efficiency. It matters more once a car has more power, grip and weight transfer. This page covers the basics and what changes on a modified car. Tyre models are compared on the rest of the car tyres section.

Why pressure matters

  • Under-inflation cuts fuel economy and performance, wears the tread edges faster and can cause overheating and early tyre failure. It is the leading cause of tyre failure; a 2001 US NHTSA study found 40 per cent of passenger cars had at least one tyre under-inflated by 0.4 bar (6 psi) or more.
  • Over-inflation can cause discomfort, reduced performance and faster wear in the centre of the tread (Wikipedia: Tire pressure).

Cold pressure, hot pressure and temperature

The recommended value is a cold inflation pressure: measured before driving, after the tyres have cooled, which is why checking in the morning is advised. It is a gauge pressure, not an absolute pressure, and it is printed in the owner's manual and on the tyre placard. Pressure changes with temperature, with daily swings and with the seasons: a tyre set correctly in summer may be under-inflated in winter, so check whenever the season changes.

Altitude has a small effect: the atmospheric pressure drops about 0.5 psi (0.11 bar) per kilometre of climb, so a car driven from high ground to sea level can end up under-inflated by up to about 0.2 bar. Tyre pressures rise as the tyre heats during hard driving. Do not bleed pressure from a hot tyre to bring it down to the cold figure, because it will then be under-inflated when it cools. This wiki does not give a hot-pressure target, because it depends on the tyre, the use and the maker's guidance.

When load or tyre size changes

A new cold pressure has to be worked out when the tyre size or the load changes. The load is the actual weight on the tyre, with a 10 per cent margin. Two common estimates from the same source are a simple ratio, pressure = load × (maximum pressure ÷ maximum load), which can give a slightly high answer, and a power-law form with an exponent of 0.8 for load indexes below 100 and 0.65 above, which can give a slightly low one. A more detailed stiffness model is the most accurate. Pressure should stay above the calculated value and below the maximum on the sidewall.

That matters on a modified car. A heavier wheel and tyre, a different tyre size or added weight changes the load on each tyre, and a larger or wider tyre changes the pressure needed. See wheel size, offset and unsprung mass. Use the tyre maker's load and pressure tables for the actual tyre, in preference to these estimates.

Pressure as a handling adjustment

Handling can be tuned by adjusting the front or rear pressures to counter understeer or oversteer. That is a small, reversible adjustment and is best made in steps of a small amount with the same tyres, noting the change: it works alongside, and not instead of, the spring, damper and anti-roll-bar setup in coilover setup and anti-roll bars and handling balance. The source does not say which direction suits which fault, so use the tyre or vehicle maker's guidance and test progressively.

Routine

  1. Check pressures cold, with a gauge you trust, at least monthly and before any hard drive or track day.
  2. Record the pressures with the tyre size, load and conditions, so changes can be compared.
  3. After hard use, note the hot pressures and the tyre wear pattern, then adjust the cold pressures to suit.
  4. Look at the tyres for wear across the tread, damage and age. Wear at the edges suggests under-inflation, and wear in the centre suggests over-inflation.

Tyre pressure sensors, where fitted, need to be reset after a change. Tyres are safety-critical: follow the vehicle and tyre makers' limits.

Sources

  • Tire pressure. Wikipedia. Effects of under- and over-inflation, cold pressure, temperature, altitude and load-based pressure estimates. Accessed 2026-11-19.