This guide concerns the early R35 Nissan GT-R with VR38DETT and GR6, and an owner-reported HP Tuners logging anomaly. It separates scanner setup from an engine fault: an implausible data channel does not by itself establish whether the sensor, vehicle, interface, configuration or software is at fault.
Identify the engine and gearbox
For the North American 2009 model Nissan describes a 3.8-litre VR38DETT twin-turbo V6 and a rear-mounted GR6 six-speed dual-clutch transaxle. The transmission uses separate wet clutches for odd and even gears. Nissan described revised TCM programming for the 2010 model, so the year and installed calibration matter when comparing shift behaviour. Nissan: 2009 GT-R introduction; Nissan: 2010 GT-R press kit.
HP Tuners' Nissan vehicle table lists the 2009-10 GT-R VR38DETT. Verify the VIN, market, exact ECM and operating system, current interface and software requirements before purchasing or flashing. The engine listing does not establish that GR6 TCM reading, logging or calibration is supported; check each function and controller separately. HP Tuners: Nissan and Infiniti applications.
Reported case: questionable log and flashing light
A technician working on a 2009 GT-R with an MPVI4 reported a flashing engine light under heavy load when warm and an implausible intake-air-temperature reading, while the same interface displayed plausible PID data on a different vehicle. The report is owner-reported and unverified: the symptom and comparison are the technician's account, and no diagnosis, verified sensor temperature or solution is established. A successful test on another vehicle does not rule out a vehicle-specific configuration or communication issue. 2009 GT-R MPVI4 forum report; excerpt via indexed copy (the original post and attached logs were not accessible for independent examination).
A flashing malfunction indicator while the engine is running should be treated separately from the implausible log. Nissan's 2009 owner's manual associates a blinking MIL with detected misfire that may damage the emissions system; it advises avoiding hard acceleration and arranging inspection. Do not repeat full-load runs merely to reproduce it. Record diagnostic codes and available freeze-frame information before clearing anything or reading the tune; HP Tuners warns that a tune read clears DTCs. Nissan: 2009 owner's manual; HP Tuners: DTCs and freeze frame.
Rebuild and validate the scan
- Preserve the original log and configuration. Connect Scanner to this GT-R to establish its own vehicle profile, and load the vehicle defaults as a starting point. Record the VCM Suite version, interface firmware and ECM identification when seeking support. HP Tuners: scan configuration; HP Tuners: channel configurations.
- Check the channel's source module, parameter, units, polling and any applied transform; a saved channel configuration carries the ID, source, polling interval and transforms. Confirm that the gauge is fed by the intended channel or math expression: changing a display layout alone does not add an input. HP Tuners: channel selector; HP Tuners: layouts.
- Compare the suspicious value with a second suitable diagnostic instrument and the correct year-specific Nissan service procedure under known conditions. Check wiring, connectors and sensor output where the service procedure directs. Agreement between displays does not, on its own, prove a sensor or calibration is correct. Escalate reproducible anomalies and original files to HP Tuners support; do not alter a fuel or timing table to compensate for an unverified channel.
GR6 context when tuning
Engine torque delivery and gearbox clutch management interact. EcuTek's separate GT-R TCM discussion describes gear-change torque reduction and clutch pressure as factors in modified cars. This is platform context for evaluating shift quality and transmission health, not evidence that its RaceROM features, table names or tuning steps exist in HP Tuners. Check fluid condition, temperatures and faults against Nissan's documentation, and establish the actual TCM support and available channels before interpreting a log or adjusting a calibration.
Not established
The cause of the implausible intake-air-temperature reading and the flashing MIL was not determined, and GR6 TCM support in HP Tuners is not confirmed.
Related: VCM Scanner, VCM Editor, MPVI4 and Nissan CONSULT diagnostics.