Tuning Wiki

Ignition coils supply the high voltage needed to fire spark plugs. Their wiring, drivers and charging requirements differ between systems, so identify the coil and ECU before changing parts or settings.

Inductive ignition and dwell

In an inductive system, current through the primary winding builds a magnetic field. Interrupting that current causes the field to collapse and induces a high voltage in the secondary circuit, allowing a spark to form at the plug. The voltage required varies with conditions including plug gap, mixture and cylinder pressure. Delphi: ignition coil operation and service.

Dwell is the commanded coil charging time in a system where the ECU controls charge duration. Too little can weaken ignition; too much can overheat or damage components. Use the coil manufacturer's values and the ECU's documented voltage compensation and output settings. Do not apply a dwell value from a different coil because its connector fits. Haltech: dwell time.

Capacitive-discharge ignition

A capacitive-discharge (CD or CDI) system stores energy in a charged capacitor and releases it through a compatible ignition coil when triggered. Its control unit and coil are designed as a system; the ECU trigger is not necessarily the coil’s primary power circuit. Some systems produce multiple sparks during part of the operating range, but the number and timing depend on the specific unit. Haltech’s MSD 6AL integration notes describe one such system and its ECU trigger configuration.

Confirm the ignition module, coil, trigger edge, output mode, wiring and any tachometer interface against the actual manufacturers’ instructions. A dwell setting used to charge an inductive coil directly cannot be assumed to be the right trigger setting for a CDI box. For its documented MSD connection, Haltech specifically says not to connect its ECU wiring directly to the coil. This detail is specific to that integration.

CDI coil primary terminals can carry high voltage even though they are called the primary side. Holley’s Street Fire installation instructions warn against touching or connecting test equipment to those terminals. Follow the exact product’s isolation and diagnostic procedure and use suitable test equipment; a conventional switched-12 V coil test is not universally applicable.

Distribution and control

A distributor routes a coil's high-voltage output to successive cylinders. A wasted-spark arrangement commonly fires two plugs from a paired coil, while a coil-on-plug system places a coil at each plug. The available time between events and the required trigger configuration depend on the arrangement. Delphi: coil locations and systems.

Some coils need an external igniter or a suitable ECU power driver; others include the igniter. An internal igniter does not automatically mean the module determines its own dwell. Haltech documents both ECU-controlled charge time and module-controlled arrangements. Verify signal polarity, driver capability, grounds and dwell mode for the exact components. Haltech: ignition system configuration.

Checks after a conversion

  1. Confirm the correct coil, driver, supply, ground and signal arrangement from manufacturer information. Avoid probing or connecting unknown high-voltage circuits.
  2. Check the ECU's timing reference against a timing light using the specified procedure, and confirm the commanded timing and actual timing agree.
  3. Record dwell settings, battery voltage and any misfire or trigger faults. Check plugs and wiring as well as the coil; a misfire under load does not automatically prove an inadequate coil.
  4. Validate progressively under controlled conditions and investigate overheating or misfire instead of increasing dwell without evidence.

For ECU-specific examples see ME7 ignition coil dwell and conversions and Simos 18 ignition coil dwell control.

See also: Automotive spark and ignition testers for spark-checking methods, diagnostic limitations and tool examples.