Dwell is not spark advance
Dwell is the time used to charge an inductive ignition coil before it fires; ignition advance is the crank angle at which the spark is requested. This guide addresses VAG ME7.1 and ME7.5 examples and coil conversions discussed on NefMoto. Check the actual coil, driver arrangement and software before relating any map or signal to another installation.
Too little charge time may leave inadequate spark energy; excessive charge or current can overheat a coil or its driver. The relevant coil and driver specifications, supply voltage and measured current matter. A conversion that appears to run smoothly is not, by itself, proof of correct current or long-term coil temperature.
Why voltage and coil type matter
Bosch Motorsport's P50 coil data illustrates the relationship: at 8 A primary current it lists 3.21 ms at 10 V and 2.06 ms at 14 V. Those are characteristic figures for that particular coil and current, not recommended dwell or evidence of ME7 compatibility. Bosch says the required dwell needs to be verified by current measurement. Supply and loom resistance, coil temperature and the actual power stage affect the installation.
Check whether the replacement coil has an integrated ignition power stage or relies on an external ECU/power stage, and verify the required drive signal, polarity and electrical limits from the exact coil and driver documentation. Do not infer wiring or dwell from connector shape, a similar-looking coil, or a different engine's calibration.
Identify the active ME7 calculation
In the ME7.1 dwell discussion and a related calculation thread, contributors discuss the ZUESZ function and maps including KFSZT, KFTSRL and FSZTM. Which path is active, its axes and corrections depend on the software. Contributors even disagreed over the active path in a particular 551M example; a map name or a table copied from another ECU does not settle it.
In the first thread a contributor initially suggested logging tsrldyn and later corrected this to szout_w for the final quantity being discussed, noting an additional correction in that example. Treat these names as leads to verify in the matching definition and function, not interchangeable signals across every ME7. A logged ECU output is also not the same as a direct measurement of primary current.
For comparison only, Bosch's ME7.3.1H Alfa function description describes a dwell calculation involving speed, battery voltage and temperature. It is a different application and does not establish the VAG map locations or exact control path.
Practical checks after a change
- Record the original and replacement coil part numbers, ignition driver arrangement, hardware connections, ECU software and the manufacturer's current, dwell and temperature specifications.
- Check charging voltage and voltage at the coil under relevant operation. Inspect supply, ground, connectors, plug condition and misfire faults before attributing a misfire to the dwell map.
- With a definition matched to the file, log the actual operating state, voltage, RPM, load and relevant final dwell output, and compare it with any intermediate signal. Where suitable equipment and expertise are available, measure primary current and temperature against the coil and driver limits.
- Evaluate cold start, idle, sustained load and the intended RPM range. Record the change and result; do not reuse a forum member's numeric setting without the same coil, driver, calculation and evidence.
Related pages: ME7 ignition and knock reference and ignition systems and spark plugs. Forum statements are attributed observations, and the examples have not been independently vehicle-tested by this wiki.