The coil makes the high voltage that jumps the spark plug gap. A tuned or boosted engine asks more of it, because higher cylinder pressure makes the spark harder to jump. This page covers how a coil works and the first things to check. Plug selection is on spark plugs for performance, and timing on ignition tuning. The sources used here are general reference sources, and the figures that matter for a particular coil come from its maker.
How a coil works
Battery voltage drives current through the coil's primary winding, which has a few turns of heavy wire around an iron core. When a contact breaker or transistor closes the circuit, the current builds a magnetic field and stores energy. When the circuit opens, the collapse of the magnetic field induces a high voltage in the secondary winding, which has thousands of turns of finer wire. The opening has to be timed to engine rotation so that the spark occurs at the right moment (Wikipedia: Ignition coil).
Dwell is the time for which the current flows to build up the stored energy before each spark. A longer dwell generally stores more energy, but there is less time between sparks at high engine speed, which limits how much a coil can charge. The dwell a coil needs is set by the coil maker and is a setting in the engine controller, so use the maker's figure for that coil and the supply voltage, not a general value.
Wasted spark and coil-on-plug
- Single-spark coils use a diode or a secondary spark gap to block the reverse pulse that could cause a premature spark.
- Wasted-spark systems fire two plugs at once, and the reverse pulse fires the cylinder that has no air-fuel mixture.
- Coil-on-plug gives each cylinder its own small coil mounted on its plug. If one fails, only that coil needs replacing. Coil packs, such as Nissan's 1985 NDIS design, are an alternative.
Typical outputs quoted are 15 kV for a small engine and 40 kV for a larger one, though that comes from a single parts-vendor page and is not a specification. A coil-on-plug layout also removes the plug leads between coil and plug.
When a tuned engine misfires
A misfire at high load and boost can come from the coil, the plug, the lead or the calibration. Work through them in order:
- Plug heat range and gap. The usual first change on a boosted engine is a colder plug and a smaller gap: spark plugs for performance.
- Coil condition and supply. A weak coil, a worn connector or low supply voltage reduces spark energy. Check the wiring, earths and the battery and charging system under load.
- Leads. Regular replacement of plug wires is advised, where a car has them.
- Dwell. Check the dwell setting against the coil maker's figure, and that it suits the supply voltage and engine speed. Too little dwell weakens the spark, and the wrong setting can cause misfire or an engine cut.
- Mixture and timing. A lean mixture or excess advance can cause misfire or knock that looks like an ignition fault: air-fuel ratio and wideband lambda sensors and engine knock.
A spark tester can show whether a coil fires, but not whether it fires well under cylinder pressure: spark and ignition testers.
Changing the coils
Fitting different coils, or converting from a wasted-spark pack to coil-on-plug, usually needs changes in the engine controller: the ignition mode, the ignition delay and the dwell. A coil that fits is not necessarily a coil that is configured. Use the coil maker's and controller maker's instructions for the exact setup, and check the result with a log and a misfire check. Marketing figures for spark energy are the maker's claims, and are not a result that a given engine will show.
Sources
- Ignition coil. Wikipedia. Construction, operation, wasted-spark and coil-on-plug layouts. Its design sections are flagged as needing more citations, and it gives no dwell figures, spark-energy figures or pressure effects. Accessed 2026-11-19.