Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Injectors
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Electronic port-injection systems differ in how injector outputs are grouped and when the ECU commands them. The terminology is not identical across manufacturers, so use the configuration instructions for the actual ECU. This page uses a four-stroke engine as its example: a complete cycle takes two crankshaft revolutions, or 720 crank degrees.

Grouping and cylinder phase

In sequential operation, a controller with full-cycle phase information can schedule each cylinder's injector relative to that cylinder. In a grouped or batch arrangement, injectors share a firing event or output, so the same command cannot necessarily be independently phased for every cylinder. Hardware wiring and ECU software determine the available choices.

Haltech's Elite documentation describes sequential, semi-sequential, multipoint and batch modes separately; in that implementation, full sequential timing uses 720-degree synchronisation, typically obtained using crank and cam signals. Its grouped modes have different synchronisation requirements. These labels should not be transplanted uncritically to another ECU. Haltech Elite: fuel and injection modes

A crank trigger can provide speed and position within a revolution, but on many four-stroke trigger arrangements a further phase reference is needed to distinguish the two revolutions of the cycle. A suitable cam or other full-cycle reference can provide that distinction. Some ECUs use alternative triggering arrangements or temporary cranking modes; verify the specific configuration. Haltech Elite: trigger and home signals

Start and end of injection

An injection event occupies time, so it also spans a range of crank angles while the engine rotates. An ECU may define a timing table by the start or by the end of the commanded pulse. Those values cannot be exchanged without considering pulse duration, speed, the angle reference and the ECU's sign convention. Haltech's firing-angle documentation specifies both methods for its own system. Haltech: firing-angle reference

Port-injection timing can affect mixture preparation and running, but there is no universal best angle. The injector location, valve events, fuel, engine conditions and the controller's timing convention matter. At higher speed or longer pulse widths an event covers more crank degrees. Direct injection has distinct pressure and combustion constraints and should be analysed using its own ECU documentation.

Checks before changing modes

  1. Identify output wiring, injector impedance and driver capability. An individually timed output requires suitable control of the relevant injector; check the actual harness and ECU documentation.
  2. Verify trigger and phase inputs, firing order and timing reference with the manufacturer's procedure. A plausible RPM signal alone does not prove correct cylinder phase.
  3. Confirm the meaning of each angle and pulse-width parameter, then log synchronisation, fuel pressure and measured versus requested lambda. Make changes under controlled conditions with a known-good calibration available.
  4. Revalidate starting, idle, transients and load. A change of mode is not automatically a power increase and may require recalibration.

Related reading: Crankshaft position sensor diagnosis, Port injector calibration and duty cycle, and Petrol direct injection and combustion modes.