Tuning Wiki

The crankshaft position sensor supplies the ECU with information used to determine engine speed and crank position. A missing or implausible signal can contribute to a no-start, stalling or intermittent running, but a fault code alone does not identify which component has failed. Check the sensor, trigger target, wiring and ECU input using the service information for the vehicle. HELLA: crankshaft sensor

Identify the sensor before testing

Inductive (variable-reluctance) and Hall-effect sensors are common designs. An inductive sensor produces a changing analogue voltage as the target passes; a Hall sensor produces a switched signal and requires the correct circuit supply. Signal characteristics, wiring and test procedures vary. A connector's pin count or the sensor's appearance does not reliably establish its type. Use the exact vehicle wiring diagram and sensor information. Delphi: testing a crankshaft position sensor

Do not apply a resistance test to an unidentified sensor. HELLA cautions that an ohmmeter can damage a Hall sensor. Follow the manufacturer's procedure and disconnect the sensor or controller only as directed. Do not apply power or a test lamp to an unknown ECU circuit.

Start with evidence

  1. Record fault codes, freeze-frame data and whether the fault occurs cold, hot, during cranking or when driving. Check battery condition and cranking speed before interpreting a low signal.
  2. Inspect the connector, terminals and harness for looseness, oil or water contamination, damaged insulation and abrasion. Check sensor mounting and the trigger target for damage or debris where accessible. Use the specified sensor-to-target clearance if the design permits adjustment.
  3. Observe engine-speed data while cranking. An absent or unstable reading is a useful clue, but a displayed RPM does not establish that every tooth and synchronisation event is correct.
  4. Identify test points and reference voltages from the appropriate diagram. Where specified, check the sensor's supply and ground under the conditions of the fault; a powered Hall sensor needs a healthy circuit as well as a switching output.
  5. Capture the signal with a suitable oscilloscope using approved connections and settings. Compare its shape, timing and amplitude against an applicable known-good waveform and manufacturer information at a comparable speed. If cam/crank correlation is suspect, capture both signals simultaneously and follow the vehicle-specific procedure.
  6. If the signal is wrong at the ECU but correct at the sensor, investigate the intervening circuit and connections. A correct waveform at the ECU does not by itself prove mechanical timing or ECU processing is correct. Recheck after repair under the conditions that produced the complaint.

Interpreting a waveform

Inductive signal amplitude depends on speed and sensor/target conditions; a weak cranking waveform may have several causes and must be assessed against the correct application. A Hall signal is normally a switched waveform, but its voltage levels and pull-up arrangement depend on the circuit. A deliberate gap or pattern in a trigger wheel can provide a reference: do not label every repeating gap a missing tooth fault without identifying the actual wheel pattern. A damaged target, wiring interference or an incorrect sensor gap can also distort a signal. HELLA: sensor designs and checks

Keep hands, clothing and test leads clear of rotating parts. Follow the vehicle manufacturer's safe cranking procedure and use appropriate back-probing or breakout equipment.

See also the illustrated common crankshaft position sensor faults guide for symptoms, circuit checks and related diagnosis.