Accessory connectors in AUMOVIO MK 100 UHP technical manual v2.1, figures 12–14, pages 17–18. These are accessory connector positions, not HECU positions. This applies to the described supplied kit hardware; check actual part numbers, connector orientation and revised supplier documentation.
Supplied PS20 external brake-pressure sensor
The manual identifies PS20 part 10.0522-9963. It warns against using a different external pressure sensor with this kit.
| Sensor contact | Function |
|---|---|
| 1 | Ground |
| 2 | Signal output |
| 3 | Power supply positive |
Supplied IMU connector
| IMU contact | Function |
|---|---|
| 1 | Ground |
| 2 | CAN IMU low |
| 3 | CAN IMU high |
| 4 | 12 V supply |
Supplied rotary mode switch
| Switch pin | Wire colour | UHP HECU connection |
|---|---|---|
| 1 | Red | 22, ABS_MODE_SW_SENSEEP |
| 2 | White | 23, ABS_MODE_SW_SIG |
| 3 | Black | 29, ABS_MODE_SW_GND |
The manual warns to use the supplied switch. Consult the maker’s diagrams for connector face and orientation, and the separate HECU pinout for the ABS-only unit. Source: AUMOVIO MK 100 UHP technical manual v2.1, pages 17–18 and 22.