Tuning Wiki
Browse AUMOVIO

Selected positions on the 58-way HECU in the AUMOVIO MK 100 UHP Technical Manual v2.1, ABS-only diagram figure 17 and pin details section 6.3. This is the manufacturer’s UHP wiring scope, not a generic MK 100 or a custom vehicle-harness allocation. Unlisted cavities are not assigned here. Identify connector orientation using figure 18 in the cited source.

PinFunction in ABS-only diagram
1KL30_P battery supply; 40 A fuse
45KL30_V battery supply; 40 A fuse
34KL15 ignition supply; 5 A fuse in diagram
14Ground
58Ground
31Vehicle CAN high
16Vehicle CAN low
28Baud-rate switch ground
41Baud-rate switch signal
27Private CAN high
42Private CAN low
11Rear right wheel speed signal
10Rear right wheel speed ground
9Front left wheel speed signal
8Front left wheel speed ground
7Rear left wheel speed signal
6Rear left wheel speed ground
5Front right wheel speed signal
4Front right wheel speed ground
53PS20 pressure sensor SENSEEP
40PS20 pressure sensor ground
55PS20 pressure sensor signal
47ABS warning lamp output
56DTC warning lamp output
57Vehicle-speed TACHY_OUT
43Brake light output
22ABS mode switch SENSEEP
29ABS mode switch ground
23ABS mode switch signal
54ABS off switch

For this documented configuration, both baud-rate switch pins open selects 1 Mbit/s; bridging pins 28 and 41 selects 500 kbit/s. Vehicle CAN and the IMU/private CAN are separate. The diagram shows 40 A main fuses; the detailed table specifies MAXI type for KL30_P and recommends 40 A for KL30_V. See the exact manual for electrical limits, wiring, commissioning and software requirements.

Source: AUMOVIO MK 100 UHP technical manual v2.1, pages 22 and 36.

Output loading

The manufacturer says the warning-lamp pins are signal outputs for transistor logic, not direct lamp supplies. The brake-light activation signal has a 20 mA maximum and must not directly power the brake lamps; the vehicle-speed output is intended for another ECU rather than a direct analog gauge connection. Follow the manual’s circuit and requirements. AUMOVIO MK 100 UHP manual v2.1, pages 19–20.