Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Datalogging and telematics
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
AiM

ECULog is a compact logger for ECU and compatible expansion data. An external GPS module can be connected; do not assume it contains XLog's integrated GPS and inertial system. For the range overview see AiM in-car dataloggers.

AiM ECULog
AiM ECULog. Image: AiM, reproduced with permission; AiM product picture library.

Specifications

ItemSpecification
ECU connectionCAN, RS232 or K-Line; requires the appropriate ECU cable
ExpansionGPS09c, ACC3, LCU and supported SmartyCam modules
Storage4 GB internal plus 16 GB removable USB-C memory
External power9–15 V
Connectors / case5-pin EXP and 7-pin ECU Binder 712; IP67

Specifications and kit contents: AiM AiM ECULog technical documentation. Check hardware generation and exact kit.

Pinout

AiM identifies Binder 712 female sockets in external device view. ECU is seven-pin, so the eight-pin XLog connector table must not be applied.

EXP, five pins

PinFunction
1CAN high / CAN+ expansion
2Ground
3+Vb out
4CAN low / CAN− expansion
5+Vb external

ECU, seven pins

ItemSpecification
1CAN ECU+
2CAN ECU−
3+Vb external
4ECU RS232 TX
5ECU RS232 RX
6K-Line
7Ground

Wiring and installation

ECULog ECU, supply and expansion paths
ECULog ECU, supply and expansion paths; original Tuning Wiki illustration based on AiM documentation. Schematic diagrams do not show physical connector positions unless explicitly labelled.

AiM lists separate 2 m CAN/RS232/external-power and CAN/OBD-II/K-Line/external-power kits. Select the correct ECU protocol; GPS, sensor and camera expansions require compatible modules and the right cables.

Choose the correct model-specific lead and configure the ECU protocol in Race Studio 3. A connector shape alone does not establish vehicle compatibility. Confirm every cavity number, signal level, ground, power source and electrical limit in the linked AiM documentation before wiring; diagrams are from the device view or a conceptual schematic as stated. Secure the loom and make connections with power disconnected.

Software and further reading

Race Studio 3 Analysis example with data traces and synchronised video
Race Studio 3 Analysis example with data traces and synchronised video. Image: AiM, reproduced with permission; manufacturer source.

Analysis and download: ECULog sessions can be transferred using its removable USB-C key. Race Studio 3 Analysis can compare the recorded ECU and expansion data; GPS and video views require compatible equipment and recordings. AiM model guidance. Download the Windows software from AiM Race Studio 3 software downloads. For capabilities and compatibility see AiM data-log analysis software.

Use AiM Race Studio 3 to configure supported devices and analyse recorded sessions. Check the specific ECU protocol and cable before connection; not every source exposes every channel. Manufacturer references: model documentation.