Bosch DDU 11 combines a 6.5-inch programmable display with 4 GB basic logging of 100 channels at 20 Hz. Full logging, a second partition, USB recording and external GPS are options. Additional inputs depend on IO_EXTENS. Bosch DDU 11 specification.

Connector and pinout
Mating connector TE 3-1437290-7, terminals 3-1447221-4. Pins 14/21 can be CAN 2 or RS232 and require IO_EXTENS. USB pins require DATA_USB. Identify cavities by the manufacturer's diagram and the actual connector. Bosch product pin configuration.

| Pin | Signal (Bosch designation) | Availability |
|---|---|---|
| 1 | KL30_KL15/UBAT | Included |
| 2 | SENSGND | Included |
| 3 | SENSPWR (5 V or UBAT switched) | Included |
| 4 | SIG2_IN | IO_EXTENS |
| 5 | SIG4_IN | IO_EXTENS |
| 6 | USB_GND | DATA_USB |
| 7 | USB_PWR | DATA_USB |
| 8 | KL31/GND | Included |
| 9 | SIG5_IN_LAPTRG | IO_EXTENS |
| 10 | SIG1_IN | IO_EXTENS |
| 11 | SIG3_IN | IO_EXTENS |
| 12 | USB_DN | DATA_USB |
| 13 | USB_DP | DATA_USB |
| 14 | CAN_2_H_RS232_TX | IO_EXTENS |
| 15 | CAN_1_H | Included |
| 16 | ETH_CHANNEL0_TXN | Included |
| 17 | ETH_CHANNEL0_TXP | Included |
| 18 | ETH_CHANNEL0_RXN | Included |
| 19 | ETH_CHANNEL0_RXP | Included |
| 20 | TIMESTMP_INOUT | Included |
| 21 | CAN_2_L_RS232_RX | IO_EXTENS |
| 22 | CAN_1_L | Included |
| 23 | ETH_CHANNEL1_TXN | Included |
| 24 | ETH_CHANNEL1_TXP | Included |
| 25 | ETH_CHANNEL1_RXN | Included |
| 26 | ETH_CHANNEL1_RXP | Included |
Installation and related information
Confirm the precise model, hardware revision, enabled options and manufacturer's wiring diagram before connecting. Use correct power protection, sensor limits and the chosen ECU protocol; a compatible connector does not guarantee compatible data. Configure in the appropriate Bosch software and verify a short recording or connection. See the Bosch Motorsport manufacturer overview.