The GS19.02 is an electronic transmission controller used in certain ZF 6HP26 mechatronic assemblies. In a Jaguar 6HP26, the TCM sits on the hydraulic valve body and connects to the vehicle through a 16-way transmission connector; it uses speed, selector, engine and vehicle information to control shifts. Jaguar 2004-model-year 6HP26 on-board-diagnostics description.


Identification and compatibility
Jaguar specialist Old Jaguar's 6HP part-number guide associates GS19.02 mechanical-shift 6HP26 units with Jaguar S-Type X202, XJ X350 and XK X103 and cites Bosch 0260550001 or 0260550011 and ZF 0501213094 or 0501213414. This is a specialist's application list, not a ZF interchange approval: check the actual plate, control unit hardware/software and vehicle VIN, engine, selector and market. The same Bosch hardware number found on a different vehicle is not proof the software or assembly is suitable. The separate 6HP family guide covers mechanical variants.
Jaguar 6HP26 16-way connector example
The following functions transcribe the Jaguar 6HP26 pin-assignment table in William Henney's ZF6HP26 training presentation. It lists an example with M-shift and touch-shift signals; the source does not tie the table to the Bosch part numbers above or a VIN. It shows a numbered connector photograph but does not unambiguously state the view orientation: match the manufacturer drawing and moulded cavity numbers with the vehicle-specific wiring document before making connections. “Not used” means that source example only. These are source-documented assignments, not independent bench verification.
| Cavity | Function in cited example |
|---|---|
| 1 | M shift program |
| 2 | CAN low |
| 3 | ISO K (listed as example application) |
| 4 | Touch −, manual downshift |
| 5 | Touch +, manual upshift |
| 6 | CAN high |
| 7 | Not used in source example |
| 8 | Not used in source example |
| 9 | Terminal 15 wake-up |
| 10 | P/N signal, starter inhibit |
| 11 | Not used in source example |
| 12 | Not used in source example |
| 13 | Terminal 31-1 ground |
| 14 | Terminal 30 permanent positive |
| 15 | Not used in source example |
| 16 | Terminal 31-2 ground |
Do not apply the table to Jaguar 6HP26/28 shift-by-wire, Land Rover or BMW modules without their specific documentation. The presentation shows a different shift-by-wire example with LIN at cavity 8. Obtain the correct fuse, power sequencing and termination requirements; never infer them from a family name.
Factory programming and calibration tools
Jaguar's 2004 model-year document describes vehicle diagnosis. Jaguar technical training reproduced by Manualzz states that replacement mechatronics in its documented 6HP26 application require programming with WDS and an adaptation drive. This is service configuration, not by itself a custom tuning capability.
PCMflash lists a Jaguar/Land Rover transmission module with 6HP26/6HP28 read, write and checksum capabilities; its module 81 manual gives the protocol family. Identify the specific vehicle and controller and check the supplier's current connection method and function list. Magicmotorsport FLEX lists 6HP bench duplication in its compatibility table; duplication is not evidence of calibration editing for this particular hardware ID. Original-file recovery and stable power are essential; tools and appropriate calibration software are separate.
See ZF gearbox and transmission control. Sources reviewed 17 November 2026.