Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Gearboxes
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Mitsubishi's W6DGA Twin Clutch Sportronic Shift Transmission (TC-SST) is a six-speed automated gearbox with two wet clutch paths. Mitsubishi's TSB 16-22-003 identifies 2008–2015 Lancer Evolution, 2009–2015 Lancer Ralliart and 2009–2011 Lancer Sportback Ralliart TC-SST vehicles in its North American scope. Confirm vehicle, market, transmission, controller and software and consult the current service information; the bulletin was issued in 2016 and is not proof that the same repair policy applies today.

How the transmission works

Mitsubishi describes separate odd- and even-gear shafts with synchronised gears. Wet clutch packs connect the respective shafts, while hydraulic servos operate shift forks. Sensors monitor clutch speeds and fork positions; the transmission control module and valve body form the mechatronic assembly. This is a dual-clutch transmission, not a single-clutch automated manual or a torque-converter automatic. Mitsubishi TSB 16-22-003, operation overview.

Capture the complaint

The Mitsubishi diagnostic worksheet records mode, hot or cold conditions, affected upshifts or downshifts, noise, leaks and fault status. Save engine and transmission faults and freeze-frame data before clearing. Check battery and supply condition and use the correct diagnostic tool to compare requested and actual gear, relevant input speeds, temperature and clutch or shift state where supported. A harsh shift or speed discrepancy alone does not identify a failed mechatronic assembly or clutch pack.

For the covered 2016 bulletin procedure, Mitsubishi distinguishes a service-required message from an over-temperature warning and describes protective actions as temperature increases. Follow the actual vehicle's handbook for warnings and seek the appropriate service support; a temperature warning is evidence to investigate, not a universal temperature or a reason to ignore fluid loss. The bulletin also instructs technicians to check connectors and CAN communication as part of its diagnostic path. Mitsubishi TSB, diagnostic worksheet and pp. 7–8.

Examples of model-specific fault information

Mitsubishi's TSB 13-22-003 diagnostic manual describes P0715 and P0716 as different conditions affecting the first, odd-gear input-shaft speed-sensor system in its TC-SST diagnosis. It warns that network faults can produce misleading fault codes and directs CAN-bus checks before the illustrated diagnosis. The exact monitor, conditions and repair branch must be matched to the model year and controller; a speed code alone is not proof that a specific clutch or gear is defective.

Distinguish a shift request or actuator problem from sensor feedback, hydraulic control, power supply, engine torque delivery and gearbox mechanical issues using the appropriate vehicle-specific plan. Inspect leaks and cooling-system evidence where the current procedure directs. A symptom under only one mode or temperature narrows the test conditions, but does not by itself isolate a component.

Programming and service boundaries

The 2016 Mitsubishi bulletin describes a service case in which a new mechatronic assembly's controller requires programming and the prescribed teach-in. It treats the 2008 Evolution procedure differently from later cars and warns that some diagnostic functions move the vehicle or raise engine speed. Do not copy a software file, coding sequence, oil quantity or teach-in from a different year; use current Mitsubishi instructions, matching equipment and proper workshop precautions. A reset cannot repair a supply, cooling or mechanical fault.

See electronic gearbox guide, dual-clutch flywheels and automated clutch control.