Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning Tools
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
Flashing and tuning tools
Manufacturers
EVC
EVC BSL100 bootstrap loader module with cables and power supply
EVC BSL100. Image credit: EVC electronic. Image source.

← EVC electronic

BSL100 is EVC’s USB interface for Infineon TriCore boot mode. EVC says it is not a successor to the BDM100. Both reach the processor without a socket programmer, but boot mode uses a CAN bus of the processor rather than pins that exist only for background debug. On the Bosch boards EVC describes, that connection is a 14-pad array that can look like a BDM footprint.

Putting the processor into boot mode needs a board-specific connection. EVC says the simplest case is one processor pin held to ground, using the supplied needle, wire and tripod, with the wire on the BSL130.L probe. The BSL100 supplies and controls the programming voltage over the probe. The positioning frame is the BDM140.P, with a BSL130 or BSL131 probe. EVC says the interface recognises the TC1766, TC1767, TC1796 and TC1797 processors and the external memories 29CD16, 29CD32, 58BW16BB and BT. Recognition of a processor family is not coverage of every board that uses it. EVC publishes separate lists of control units and vehicles it has tested.

BslToGo is the companion application for reading and programming with the BSL100. WinOLS can also drive the interface. EVC says manufacturers closed boot mode with a password, which it identifies with TPROT levels 8 to 10. It says that password can be read on some applications, including some VAG and older BMW units, and not on others, and it names Volvo as a case where it cannot. The BSL-ADP is a separate USB interface, used only with a BSL100, for passwords the BSL100 alone cannot read. It then uses boot mode to read or program the processor, EPROM or EEPROM. The exact pads are in EVC’s instructions for that control unit. This page does not describe them.

EVC BSL-ADP module with test leads, USB cable and power supply
EVC BSL-ADP. Image credit: EVC electronic. Image source.

EVC also lists a BSL-DRV CAN driver for boards whose CAN interface is not fitted, currently naming the Opel EDC17CP44 and EDC17C59, and probe sets BSL131 and BSL132 for non-Bosch boards and for Bosch boards that need one or more boot pins.

Sources