Tuning Wiki
Browse EVC
Diagram of WinOLS and the EVC hardware that connects to it
How EVC describes WinOLS sitting under its own hardware and other programmers. Image credit: EVC electronic. Image source.

EVC electronic, at evc.de, has built chiptuning software and hardware since 1991. The company says it develops and manufactures nearly all of its own products and is ISO 9001 certified. WinOLS is the editing software at the centre of the system. The hardware below is what EVC currently names as part of that system. WinOLS 5 no longer supports the earlier Megaprommer MP2240P and OLS16 programmers.

Tools

  • WinOLS, including checksum plug-ins and import modules for DAMOS and ASAP2 files, tester files, and plug-ins named for NewGenius and CMD Flash.
  • BDM100, with BdmToGo as a separate read and program application for that interface. BdmToGo files are encrypted and open in WinOLS.
  • BSL100 and BSL-ADP, with BslToGo, for Infineon boot mode.
  • OLS300, an EPROM simulator and access monitor. It followed the OLS16.
  • UCM100, an OBD-II interface for standard live data and fault memory, shown inside WinOLS.
  • SPI-Wizard. EVC publishes SPI-Wizard III. The previous generation’s installation guide on the same site identifies it as a Frieling Racing serial programmer.

Seeing which map is in use

EVC’s access-indicator comparison distinguishes several ways of watching a running control unit. The OLS300 can show accesses to a map and to its axes, and can change map values while the engine is running. EVC limits that method to control units up to ME7 and EDC15. The UCM100 shows OBD live values and does not show map accesses. The same table lists a VehiCAL logger and other J2534 loggers as ways to record many values, with extra WinOLS licences for some of those combinations. Which method applies depends on the control unit and the licence.

Sources