Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Performance
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Power figures are quoted in several units, and torque and power are often confused. This page gives the relationship between them, the conversions, and the difference between the places where power is measured. How dyno graphs are produced is on dyno graphs explained and dynamometer measurement and interpreting results.

The relationship

Power is torque multiplied by rotational speed. In imperial units, power in horsepower equals torque in pound-feet times engine speed in rpm, divided by 5,252. The constant is 33,000 foot-pounds per minute divided by 2π, rounded. With torque in inch-pounds the divisor is 63,025 (Wikipedia: Horsepower). In metric units, power in watts is torque in newton-metres times angular speed in radians per second, which is rpm × 2π ÷ 60.

So at the same torque, more engine speed means more power, and an engine's power peak usually comes at a higher speed than its torque peak, because power keeps rising with speed while torque is still falling slowly. Torque is the twisting effort at the crankshaft, and power is how fast that work is done, which is why gearing lets a lower torque at higher speed do the same job: gearing, final drive and road speed.

Units

  • Imperial (mechanical) horsepower is 550 foot-pounds per second, about 745.7 W.
  • Metric horsepower (PS, cv, CV and similar) is 75 kgf·m/s, about 735.5 W, which is about 98.6 per cent of an imperial horsepower.
  • Electrical horsepower is exactly 746 W.
  • Kilowatts. One kilowatt is about 1.341 imperial horsepower (a calculation from the 745.7 W figure).

The EU has permitted horsepower only as a supplementary unit since 1 January 2010, and most countries use watts. When comparing figures, check which unit, which standard and which measurement point each uses.

Worked example

This is an illustrative calculation, not data for any engine. Take 300 N·m of torque at 5,000 rpm.

StepValue
Angular speed, 5,000 × 2π ÷ 60523.6 rad/s
Power, 300 × 523.6157.1 kW
In imperial horsepower, 157.1 ÷ 0.7457210.7 hp
In metric PS, 157.1 ÷ 0.7355213.6 PS
Check with pound-feet: 300 N·m is 221.3 lbf·ft, and 221.3 × 5,000 ÷ 5,252210.7 hp

Where power is measured

  • Brake horsepower (bhp) is measured with a dynamometer at a specified point, such as the crankshaft or the transmission output, before drivetrain losses.
  • Shaft horsepower is crankshaft power minus the transmission losses, from bearings, gears, oil drag and windage.
  • Wheel horsepower (whp) is shaft power minus the losses in the joints, differential, wheel bearings and tyres.

US figures from before 1972 are SAE gross, measured without accessories, so they read higher than later SAE net or DIN 70020 figures for the same engine. A wheel figure is always lower than a crank figure for the same car, and the ratio is not a fixed percentage. Compare power numbers only on the same measurement point, standard and correction method: see engine performance upgrades for validating a change.

Sources

  • Horsepower. Wikipedia. Torque and power formula, unit definitions and the brake, shaft and wheel measurement points. The article does not explain why torque and power peak at different speeds; that explanation here follows from the formula. Accessed 2026-11-19.
  • The worked example is arithmetic with illustrative values using the formulas above.