Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Maserati

Biturbo-era Maseratis changed from carburettor to electronic injection in 1986. This page records what the sources establish about each system. ECU part numbers, memory devices, pinouts and map layouts are not established yet and are deliberately not listed.

Carburettor cars (1981–1986)

  • A single twin-choke Weber carburettor sits in a cast-alloy plenum that is pressurised by two small IHI turbochargers. A 2.5 litre example is described with a computer-controlled wastegate, a maximum of 11 psi, 185 bhp and about 225 lb-ft at roughly 3,000 rpm.
  • Early cars are listed with a Weber 36 DCNVH 16/100. The 2.5 litre cars of 1984–85 use a Weber DCNVH under an aluminium plenum. A Weber 34 DAT is reported on 1986 2.5 litre cars and is considered less efficient and harder to keep in tune.
  • Setting up the carburettor and fuel mixture is regarded as fiddly once the turbos start to spool. No jet sizes, emulsion tubes, air correctors or float settings for Biturbo applications have been found, so none are given. General Weber information is on Weber DCNF, ICT and ICH and carburettor makes and model families.
  • Because the carburettor sits upstream of the turbos, mixture and boost control affect each other; see MABC boost control and tuning.

Injection cars (1986 onward)

  • Injection arrived in 1986 with the Biturbo i and Si and the 420i. The system is a Weber-Marelli unit that controls both fuel and ignition.
  • The Racing used Magneti Marelli controllers for ignition, injection and boost.
  • The Shamal carries a Marelli IAW integrated ignition and injection ECU, one per cylinder bank. The Ghibli II also uses Weber-Magneti Marelli IAW injection and ignition.
  • No ECU detail was found for the Quattroporte IV. A Marelli IAW 4CM is listed for the 3200 GT (1998 onward, outside this page's scope) and should not be assumed for earlier cars.

Typical electrical and ignition faults

The ignition ECU is a frequent suspect. A failed ignition module is often traced back to a faulty coil, so the coils should be tested or replaced together with a damaged unit. Bad earths and corroded connectors can also damage control units or cause intermittent running. A Weber/Marelli MAP sensor is part of the injection system.

A Maserati-club repair manual covers Weber IAW fault-finding for the 1989–93 4.24v; it is general rather than Maserati-specific, so check procedures against factory data.

Not yet established

  • ECU part numbers per model and year, connector pinouts, EPROM types and map definitions.
  • Which IAW sub-variant belongs to which AM engine code.
  • Carburettor jetting for each Biturbo variant.

Scans, part numbers and photographs with sources are welcome. Related: models and years, engines, airflow meter manufacturers.

References