Biturbo-era Maseratis changed from carburettor to electronic injection in 1986. This page records what the sources establish about each system. Part numbers, memory devices, pinouts and map layouts for the ECUs are not established in the sources found so far and are deliberately not listed.
Carburettor cars (1981–1986)
- A single twin-choke Weber carburettor sits in a cast-alloy plenum pressurised by two small IHI turbochargers. An Old Cars Weekly piece on a 2.5 litre car describes a computer-controlled wastegate with a maximum of 11 psi, 185 bhp and about 225 lb-ft at roughly 3,000 rpm.
- Early cars are listed with a Weber 36 DCNVH 16/100. The 2.5 litre cars of 1984–85 are described with a Weber DCNVH under an aluminium plenum; a Weber 34 DAT is reported for 1986 2.5 litre cars, described by one source as less efficient and more troublesome to maintain (Wikipedia).
- The owner in the Old Cars Weekly piece describes carburettor and fuel settings as finicky once the turbos spool. No jet sizes, emulsion tubes, air correctors or float settings for the Biturbo applications were found, so none are given here. General Weber information is on Weber DCNF, ICT and ICH and carburettor makes and model families.
- Because the carburettor sits on the plenum side of the turbos, the fuel mixture and the boost controller interact; see MABC boost control and tuning.
Injection cars (1986 onward)
- Fuel injection arrived in 1986 with the Biturbo i and Si and the 420i; Maserati describes a Weber-Marelli electronic system controlling both fuel and ignition (Maserati Classic).
- The Racing is described with Magneti Marelli engine controllers for ignition, injection and boost.
- The Shamal is described with a Marelli IAW integrated ignition and injection ECU, one per cylinder bank; the Ghibli II is described with Weber-Magneti Marelli IAW injection and ignition (Shamal, Ghibli).
- The Quattroporte IV pages give no ECU detail. The 3200 GT (1998 onward, outside this page's scope) is listed by a tuning shop with a Marelli IAW 4CM ECU; do not assume that unit applies to earlier cars.
What owners report about the electronics
From a Biturbozentrum thread (single-source, forum evidence, treat as leads): the ignition ECU is a common failure point; one owner said replacing it cured their problem, and a repairer's view was that a failed ignition module is usually caused by an ignition coil fault, so coils should be checked with a replacement. A ground fault is also reported as having damaged an ECU. Old Cars Weekly lists electrical faults, usually corroded connections and poor grounds, as a known problem. A MAP sensor of Weber/Marelli manufacture is mentioned.
A Maserati-club repair manual download covers Weber IAW fault-finding for the 1989–93 4.24v; it is described there as general rather than Maserati-specific, so verify procedures against factory data.
Not yet established
- Exact ECU part numbers per model and year, connector pinouts, EPROM types and map definitions.
- Which Weber-Marelli IAW sub-variant applies to which AM engine code.
- Carburettor jetting for each Biturbo variant.
Evidence is welcome: add scans, part numbers and photographs with sources. Related: models and years, engines, airflow meter manufacturers.