Tuning Wiki

Water or water-methanol injection sprays fluid into the intake air to cool the charge and resist knock. It is covered briefly on charge cooling, intercoolers and water injection. This page covers the system as a whole, its fluid and its failure modes. Engine-specific fault response is on ME7 water methanol injection and fault response and Simos 18 water methanol injection and failsafe.

What it does

Water injection sprays water into the intake air, the air-fuel mixture or the combustion chamber. The water cools the charge and suppresses premature ignition at hot spots, which is knock. A cooler charge allows higher compression, more boost or more aggressive ignition timing, and on some engines water injection alone improves power and efficiency (Wikipedia: Water injection (engines)). BMW M's account of its production system is built on the same logic: cooling the charge is what lets it advance the spark and raise boost (see ignition tuning).

The BMW M4 GTS is the published production example. Its system used three injectors, and boost rose from 17.2 to 21.6 psi, with BMW stating a gain of 50 hp (37 kW), to 493 hp. That is one manufacturer's figure for a factory-engineered system, not what an aftermarket kit will give on another engine.

The fluid

Many systems use water mixed with alcohol, usually close to 50-50, plus a small amount of water-miscible oil. Water provides most of the cooling. The alcohol burns and works as antifreeze, and the oil protects injection and fuel components from corrosion. Use the fluid the system maker specifies, and the correct mixture for the climate.

Risks

  • The knock margin depends on it. If the tank runs dry or a nozzle blocks, the charge is hotter than the calibration assumed. A system that raises the boost or timing on the assumption that injection is working needs a way to detect that it has stopped and then reduce boost and advance. This is why the engine-specific pages cover delivery monitoring and fault response.
  • Freezing. Plain water freezes, and the alcohol content lowers the freezing point. Check the mixture against the lowest temperature the car will see.
  • Corrosion and contamination. The oil in the mixture limits corrosion. Use clean fluid, and check filters and lines.
  • Refilling. An extra fluid to top up is a practical burden. A system that depends on a full tank is only as reliable as the habit of filling it.
  • The wrong fluid. Putting the wrong liquid in the tank is a serious fault. Label the filler, and keep fuels and other fluids out of the system.
  • Methanol is flammable and toxic. Store and handle it as the supplier directs.

Setting it up

  1. Choose a system with delivery monitoring, such as a flow or pressure sensor, a level sensor and a fail-safe output, and wire it to the maker's instructions.
  2. Decide the strategy first: injection as a safeguard that is only used when needed, or as a means to run more boost. The second depends on the injection working at all times.
  3. Calibrate with a tuner who knows the system, logging knock correction, lambda and charge temperature: air-fuel ratio and wideband lambda sensors.
  4. Check that the engine reduces boost or advance safely if the injection fails. Test this on the dyno or a safe road, not by guesswork.
  5. Check nozzle position, spray and mixing, and that water does not pool in the charge pipes or reach the cylinder in quantity.

Added methanol is also a fuel, so very high flow rates affect the mixture, as the ME7 page describes. For the engine's strength limits at higher boost see pistons, connecting rods and rod bolts and head gaskets and studs, and for boost control electronic boost control.

Sources