Tuning Wiki

Volumetric efficiency (VE) is the link between an engine's size and the air it actually breathes. It appears in every airflow estimate, from sizing a turbo to checking an intake upgrade. This page defines it, shows how it is used and lists what changes it. For the turbo-sizing use see compressor maps and turbo sizing.

Definition

Volumetric efficiency is the ratio of the fresh air that enters a cylinder during the intake stroke, measured at a reference density, to the cylinder's swept volume (Wikipedia: Volumetric efficiency). A value of 1.0 means the cylinder fills with its swept volume of air at the reference density. The engine's air mass is VE multiplied by the swept volume and the density of the air in the manifold, so the manifold-pressure term accounts for much of the effect of boost.

Estimating airflow

For a four-stroke engine:

Air mass flow = displacement × (rpm ÷ 120) × VE × manifold air density

Manifold air density is the absolute pressure divided by (287 × absolute temperature in kelvin), in pascals. That estimate then sets the fuel delivery and spark timing the engine needs, which is how engine management uses it (engine load sensing: speed density, Alpha-N and MAF).

Worked example

This is an illustrative calculation for a naturally aspirated 2.0-litre engine at 6,000 rpm, with VE 0.85, atmospheric pressure of 101.3 kPa and an air temperature of 300 K.

StepValue
Air density, 101,300 ÷ (287 × 300)1.18 kg/m³
Volume drawn per second, 0.002 m³ × 6,000 ÷ 1200.100 m³/s
Mass flow, 0.100 × 0.85 × 1.180.100 kg/s (6.0 kg/min)

Compare the boosted example on the compressor-map page, where doubling the manifold pressure roughly doubled the airflow for similar VE.

What changes it

  • Flow restrictions. Intake and exhaust restrictions reduce the inlet flow and the charge mass: air filters, intake ducting and restriction.
  • Pressure difference across the valve. A larger pressure difference across the intake valve generally raises VE across the naturally aspirated range.
  • Tuned intake and exhaust. Ram tuning can raise or lower filling depending on when the pressure waves reach the valve: inlet manifolds and runner length and exhaust system tuning.
  • Engine speed and valve timing. VE changes with speed. At higher speed the valves stay open for a larger share of the cycle, and variable valve timing addresses the change: camshafts and valve timing.
  • Boost. Manifold pressure above atmospheric raises VE as measured against atmospheric density.

Typical values and limits

A naturally aspirated engine can exceed 100 per cent with tuned intake resonance, and values of about 130 per cent are reported for DOHC four-valve engines with that tuning and in race or experimental engines. Boosted engines can exceed 100 per cent by supercharging or turbocharging. The wiki does not give a typical production figure, since it varies with the engine and the speed. VE is a measured quantity: logging manifold pressure, temperature and airflow on the engine gives a better figure than a table.

Using it well

  1. Use a measured VE at the engine speeds that matter, not a single figure for the whole range.
  2. Remember that VE changes after a cam, manifold, head or exhaust change, so an old estimate no longer applies: cylinder head, ports and valves.
  3. Check the estimate against a mass airflow reading or the fuel flow where they are available.

Sources