Tuning Wiki

Overview

Browse articles · Open overview article

A transfer box, also called a transfer case, takes drive from the gearbox and sends it to the front and rear axles, usually through separate prop shafts. On a two-speed unit, low range adds a reduction after the gearbox. That gives more wheel torque and finer control at low road speed.

Main types

  • Part-time four-wheel drive. A typical system runs in two-wheel drive in 2H and couples the front and rear outputs in 4H or 4L. With the outputs coupled, differences in axle speed during turns can build up driveline wind-up on dry, high-grip surfaces. Follow the vehicle handbook for mode and surface restrictions.
  • Permanent four-wheel drive with a centre differential. The centre differential allows the front and rear axles to turn at different average speeds. Some units have a centre lock for low-grip conditions.
  • Clutch-controlled or on-demand drive. A controlled clutch varies how much drive is passed to the other axle. Some systems also offer locked modes or low range. Range gearing and the method of coupling the axles are separate design choices.

Ford four-wheel-drive mode examples · Land Rover LT230T overhaul manual

Worked example: Land Rover LT230

The LT230 is a gear-driven, two-speed transfer box used on several Land Rover models. Drive passes from the gearbox output shaft into the LT230 input gear, through the intermediate gear train and into the centre differential, which drives both prop shafts. High and low range select the reduction. With the centre lock disengaged, the front and rear outputs can rotate at different speeds. Engaging the centre lock couples those outputs. The axle differentials still govern the speed difference between the left and right wheels.

LT230 gearing, input gears and centre-lock arrangements vary. Read the transfer-box serial number and suffix and check the vehicle handbook before ordering parts or assuming a fitted lever operates the centre lock. Ashcroft LT230 identification and variants · Ashcroft Transmissions on Tuning Wiki

Common faults and clues

  • Oil leak. Trace the oil to its source around the output seals, casing joints or intermediate shaft. On the LT230, wear can elongate the casing bore supporting the intermediate shaft, allowing leakage and contributing to whine. Check oil level and the specified lubricant for the unit.
  • Clunk on take-up or load reversal. Check prop-shaft joints, splines and mounts as well as free play in the box. Land Rover documented wear at the LT230 input gear and gearbox output splines on some earlier units. It introduced a revised, cross-drilled input gear. Confirm both mating parts and the serial suffix before specifying a repair.
  • Whine or rumble. Note whether it changes with road speed, load or range. Worn gears or bearings and low lubricant are possible causes. Compare with noise from the gearbox and axle final drives.
  • Range or lock fails to engage or release. Follow the vehicle’s shift procedure and check for driveline wind-up. Depending on the design, inspect the mechanical linkage and selector or check actuator and position-sensor faults. A warning lamp alone does not identify the failed part.

Ashcroft on LT230 casing wear · Land Rover bulletin on transfer-box backlash

Related guides include Differentials and Prop Shafts.

For factory ratios, model applications and identifying the unit fitted, see Land Rover LT230 ratios and identification.

Articles