Tuning Wiki

dynoKRAFT supplies dynamometers with its ADAQ control and acquisition system. ADAQbase is the measurement and control module; other components provide expansion, brake power, a remote and PC software. The manufacturer states that ADAQbase is available only with new dynoKRAFT dynamometers, so a third-party retrofit must not be assumed.

dynoKRAFT ADAQbase dynamometer control module showing front and terminals.
dynoKRAFT ADAQbase control module. Image: dynoKRAFT, used with permission.

ADAQbase and expansion

The ADAQ system description lists two RPM inputs, two load-cell inputs, three configurable 0–5 V inputs, a K-type thermocouple input, weather station and USB-C PC connection on ADAQbase. Its brake-control output can be configured for PWM, RC-pulse or analogue signalling. The separate ADAQexiom adds five analogue inputs and configurable relays and fan-control output; the maker describes using up to two expansion modules.

One ADAQbase's signal outputs are control commands. An eddy-current absorber needs an appropriately rated power stage. dynoKRAFT lists ADAQpower as its separate eddy-current brake supply with calibrated current control, discharge and over-current/temperature protection. Its ADAQremote offers assignable keys and a speed-target dial. Component inclusion depends on the particular dynamometer and package.

Speed-hold feedback loop from target through controller, brake actuator and dyno to measured speed.
General dyno speed-hold feedback loop; hardware and sensor locations depend on the installation. Original schematic for Tuning Wiki, CC BY 4.0.

ADAQsoftware and test modes

ADAQsoftware provides manual and semi-automatic tests, PID and non-PID brake commands, graphing, adjustable filters and correction factors. The supplier describes inertia compensation and a plugin system for additional hardware, including specified OBD or CAN adapters. Such interfaces require the relevant sensors, plugins and configuration; they do not guarantee compatibility with any arbitrary device.

For the documented A200-4WD-ML, the supplier lists inertia runs, controlled power sweeps, RPM hold, RPM-profile, load and brake-sweep modes. The listing describes two eddy brakes and a mechanical axle link, with ADAQbase, ADAQexiom and software in that model's scope of delivery. The same page identifies A200 as superseded by the A330 series; confirm details for the current model and actual hardware.

Two- and four-hub arrangements

The software page says that a four-wheel-drive hub dyno can be supported using two base controllers. Hub speed sensors, load cells, brake commands and compatible power supplies must still be provided for each intended channel. This is a documented system capability, not confirmation that ADAQbase is supplied as a standalone universal retrofit. Ask dynoKRAFT about the exact complete-dyno arrangement and support.

Compatibility and setup

ADAQpower is described as an eddy-current supply; the A200 listing also refers to a water-brake load-control mode, which requires a suitable valve and actuation interface. Do not connect a coil directly to a low-level signal output or infer a water-brake retrofit package solely from a software mode. Confirm the absorber, torque-speed and cooling envelope, channel count, brake driver, software version and sensors with the manufacturer. Calibrate the complete system and record test and correction settings before comparing results.

Related: Dynamometer control systems · Factory and aftermarket controller comparison · Dyno measurement.