A misfire is a combustion event that does not produce the expected contribution to engine torque. A rough idle, hesitation or loss of power can have many causes, so start with the operating conditions and evidence rather than assuming that a misfire code identifies a failed ignition coil.
What the ECU can detect
Many OBD systems infer misfires from small changes in crankshaft speed between combustion events. An EPA technical document describes this approach; the exact monitor, enabling conditions and cylinder attribution vary by vehicle. A stored misfire code identifies the detected condition, not necessarily the faulty part. A fault may be intermittent or occur outside the monitor's active range.
A flashing malfunction indicator can indicate a severe misfire that may damage the catalyst. The US EPA OBD guidance advises reducing speed and seeking service; follow the vehicle manufacturer's instructions for the particular warning and operating conditions.
Record the conditions first
- Record stored and pending codes, freeze-frame information, engine speed, load, temperature and whether the fault occurs cold, hot, at idle or under acceleration. Preserve the evidence before clearing codes.
- Check service information, recent repairs, electrical supply, intake connections and obvious damage. Record whether misfire counts are concentrated on one cylinder or appear across several; counter availability and meaning are vehicle-specific.
- Compare evidence from ignition, fuel, air and mechanical checks below. Use the manufacturer's test procedure and appropriate instruments rather than replacing parts solely on a code.
- After repair, repeat the relevant operating conditions and verify counters, drivability and any applicable monitors. See OBD fault codes and readiness monitors.
Separate possible causes
| Area | Checks to guide diagnosis |
|---|---|
| Ignition | Inspect plugs, coils, connectors and wiring against the engine specification. If components are interchangeable and the manufacturer's procedure permits, a controlled component swap can help determine whether the fault follows the component. NGK's plug-reading guide explains that deposits can have several causes. |
| Fuel | Check fuel quality, supply pressure and injector electrical operation and delivery using the specified method. A single-cylinder injector issue and a common supply problem require different checks. See injector test results. |
| Air and mixture | Inspect for unmetered-air or charge leaks and compare relevant airflow, pressure and fuel-trim data. An exhaust leak or misfire can also make oxygen-sensor feedback misleading. Interpret trims with operating mode and other evidence. |
| Mechanical and timing | Check compression, leakage and mechanical valve timing when evidence points there, following the engine's service procedure. Cam/crank synchronisation or sensor and wiring faults can affect more than one cylinder. |
On a modified engine, confirm plug specification, gap and ignition-system capability for the actual combination. NGK notes that the voltage required to spark can become a concern with higher cylinder pressure; it does not establish a universal replacement gap. For a model-specific example see Simos 18 misfire detection and diagnosis, and for related ignition hardware see ignition coils and dwell.