Tuning Wiki
Browse Cadillac

The 2013–2015 Cadillac ATS 2.0T provides a useful example of why a boost or fuel-trim complaint should be diagnosed before changing an HP Tuners calibration. The discussion below is centred on the LTG engine and the six-speed automatic where specified; equipment and support vary by VIN, market, model year and controller. It is not an ATS-V guide.

Engine, gearbox and support identification

Cadillac's 2014 ATS catalogue describes a 272 hp 2.0-litre turbocharged direct-injection engine. GM describes the LTG's twin-scroll turbocharger, electronically controlled wastegate and bypass, cam-driven high-pressure fuel pump and electric in-tank supply pump in its 2016 technical bulletin 16-NA-112. That general bulletin describes a later GM application, so its example pressures and specifications should not be treated as universal ATS targets. The six-speed automatic is identified as 6L45 in this 2014 ATS diagnostic case; other gearboxes exist.

HP Tuners' supported-vehicles list lists the ATS 2.0 for 2013–2015, 2016 and 2017–2018 in separate ECM entries. Its listed credits are for ECM licensing; supported additional controllers have separate licensing. Confirm the exact controller, operating system, software, interface and current TCM support before buying or flashing. The presence of an engine entry does not guarantee gearbox support.

Fuel trim and a model-specific vacuum circuit

In one technician discussion, a 2014 ATS 2.0 LTG with 6L45 repeatedly set P0171 after idling. The technician reported long-term fuel trim rising to approximately +40% at idle, with a smooth-running engine after adaptation. This is a case report, not a normal specification or proof of one particular fault.

GM bulletin PI0940A covers P0171 on specified 2013–2015 ATS and 2014–2015 CTS four-cylinder LTG/LCV vehicles with vacuum-controlled engine mounts. After normal diagnostic checks, GM directs a vacuum-only leak test of that system and explicitly says not to use positive pressure at its tank. Inspect only if the exact vehicle has the system and follow current GM service information. Do not assume every P0171 is caused by a mount leak.

Use VCM Scanner where the relevant channels are available to record engine speed, coolant temperature, short- and long-term fuel trim, MAF and manifold pressure at warm idle and a comparable stable light-load condition. Compare the trim pattern and investigate leaks, intake integrity and fuel-system problems using the correct service procedure; a trim number alone cannot identify the fault. Save a baseline and fix confirmed faults before altering airflow or fuel tables.

Boost, injection and modification context

On a healthy engine, log desired and actual manifold or boost pressure, charge-air temperature, throttle, fuel-rail pressure and its commanded value, commanded and measured lambda, spark and knock activity where supported. Check units and channel definitions: absolute manifold pressure is not the same as gauge boost. Investigate persistent rail-pressure deviation or knock before seeking additional load, and use an appropriate independent wideband when needed. Compare readings under repeatable conditions; individual trims, fuels and engine operating systems differ.

In a 2017 injector discussion, a fuel-system supplier reported using an LTG high-flow pump and injectors on its own ATS and discussed HP Tuners injector-drive control. This is a supplier's historical experience with its particular parts, not evidence that settings or flow data transfer to another injector or ECM. Obtain exact injector characterization and compatible pump data for the fitted parts; do not copy values across the LTG, LHU and LNF.

One LTG calibration supplier describes adjusting driver demand, torque, enrichment, fuel pressure, ignition and turbo settings with HP Tuners in its package. These are examples of interacting calibration areas, not a universal sequence or recommended numeric values. Changes should be matched to the actual hardware, fuel and logged response.

Six-speed automatic discussion

An owner of a modified 2015 ATS LTG and 6L45 reported seeking a change to touring-mode shift points while retaining sport-mode behaviour after a remote tune made commuting less pleasant. They mentioned consulting a Pontiac G8 forum because they considered its T43 controller similar. The post does not establish interchangeable calibrations or a verified fix, and does not identify the tuning interface by name. Identify the actual TCM and calibration first; record gear, vehicle speed, engine speed, throttle, selected mode and converter state when available. Compare the relevant operating modes with the original calibration instead of copying shift tables from another vehicle.

Related pages

Continue the conversation

If this topic interests you, consider joining the following forums. They host material referenced in this article.