Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Diagnostics
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

A diesel that cranks but does not start needs a systematic check of cranking speed, synchronisation, fuel delivery and the conditions needed for combustion. Record whether the fault is cold, hot, intermittent or follows recent work; do not assume a pressure fault means the high-pressure pump has failed.

For system layout see common-rail diesel fuel systems; for detailed tests see common-rail fuel system tests and on-vehicle injector testing.

Safety and preparation

High-pressure fuel can penetrate skin and cause serious injury. Do not loosen a high-pressure joint while cranking or running, or search for leaks by hand. Follow the vehicle manufacturer's depressurisation and isolation procedure, use correctly rated equipment and keep opened connections clean and capped. A suspected injection injury needs immediate emergency medical attention. Injector drive circuits can also carry hazardous voltage.

Diagnostic sequence

  1. Establish whether it cranks normally. Check battery condition, connections, starter circuit voltage drop and cranking speed against the engine specification. Low speed can affect both compression temperature and the pump's ability to build pressure. Avoid repeated extended cranking; follow the starter's duty cycle.
  2. Capture evidence. Read all relevant control modules and save fault codes and freeze-frame data before clearing. Look for engine speed and, where available, crank/cam synchronisation, immobiliser authorisation, rail pressure demand and actual pressure during the fault. A code identifies a circuit or condition to investigate, not necessarily a failed component.
  3. Check fuel and low-pressure supply. Confirm adequate correct fuel, filter condition, signs of water or contamination, air ingress and supply-pump operation where fitted. Measure supply pressure or restriction at the specified points and under the prescribed conditions. Some systems draw fuel under suction; do not apply a positive-pressure specification to every design. A restricted filter or weak supply can prevent the high-pressure pump from working correctly. Delphi: blocked filters.
  4. Compare rail pressure with the vehicle's starting requirement. Actual pressure that does not reach the specified starting range calls for checks of supply, pressure sensing and control, pump output and leakage. Verify a suspect sensor reading using the approved method; an implausible reading can mislead diagnosis even without a sensor code. Starting thresholds are application-specific. Delphi: hard or non-start diagnosis.
  5. Investigate excessive return only with an approved test. Injector leak-off, a pressure-control valve or another leak can prevent pressure building, but a return test must match the injector and return-circuit design. Some systems require maintained return pressure. Compare quantities under the specified test conditions; balance alone does not prove correct injector delivery or spray. Pico: solenoid injector back-leakage test and limits.
  6. If pressure and authorisation are satisfactory, check combustion and control. Follow the engine-specific checks for timing signals, injector command, glow system when relevant, compression and mechanical timing. Low compression, incorrect valve timing and other mechanical faults can resemble an injector fault. Use only the manufacturer's specified electrical test for the injector type.

After repair

Correct contamination or air leaks, prime as specified, enter injector calibration codes where required and check for leaks with the prescribed method. Confirm starting under the original cold or hot conditions, review live data and rescan. Never disconnect a piezo injector electrically with the engine running; on some systems this can leave it open and cause serious engine damage. Pico: piezo injector precautions.