Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Protocols
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
BMW

BMW uses “K-bus” for a bidirectional, single-wire body sub-bus. BMW Technical Training material describes it at 9.6 kbit/s with a signal that switches between approximately 0 V and 12 V. It can serve different functions depending on model generation; BMW’s F0x material cites examples including links involving ACSM, TCU, Comfort Access and CAS. Earlier E-series network names and participants differ, and should be checked against the vehicle’s wiring diagram.

Conceptual BMW K-bus single-wire body sub-bus with body controller, comfort, cluster and other nodes
Conceptual one-wire K-bus diagram. Node names are illustrative and are not a vehicle-specific wiring layout.

Frames and read-only examples

The BMW training reference documents the electrical layer and K-bus role but does not provide a portable body-module address table or confirmed read-only request/reply frame. No raw K-bus command or frame ID is claimed here. Older BMW I-bus captures and byte examples are documented separately on BMW I-bus; those captures are scoped to the stated E39 equipment and are not presented as a verified K-bus capture.

K-bus is not CAN, and its name does not mean it is the OBD diagnostic K-line. BMW diagnostic access uses separate diagnostic interfaces and protocols; see BMW diagnostic connections. Check the chassis-specific wiring diagram before identifying a conductor or network participant.

Source