Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Protocols
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

A single signal wire carries bidirectional serial diagnostic traffic between the tester and control units. The vehicle interface uses automotive electrical levels, so a suitable K-Line transceiver sits between the line and the tester hardware.

Tester, K-Line transceiver, ECU
K-Line diagnostics. Original Tuning Wiki diagram.

Reading the network or diagnostic trace

An older ECU may expect a five-baud or fast initialisation sequence before normal requests. A rate around 10.4 kbit/s is common. Check the ECU’s initialisation, addressing and timing requirements before interpreting a quiet line.

See KWP 2000 on K-Line and the vehicle diagnostics protocol guide.

Sources: ACTIA IME overview.