Tuning Wiki

ISO 14230 describes diagnostic communication over K-Line. The ECU and tester exchange addressed frames once communication has been initialised. A service identifier tells the ECU which diagnostic operation the tester is asking for.

Tester request, K-Line data link, ECU response
KWP 2000 on K-Line. Original Tuning Wiki diagram.

Reading the network or diagnostic trace

A negative response carries 0x7F, the requested service identifier and a reason code. Read the request and response together to distinguish refusal of a service from no reply on the line.

See K-Line diagnostics and the vehicle diagnostics protocol guide.

Sources: ACTIA IME overview.

Detailed reference

Keyword Protocol 2000 (KWP 2000) is a diagnostic protocol used by older vehicle control units. ISO 14230 specifies its use over K-Line. The series covers the physical interface, the data link, diagnostic services and requirements for emissions-related diagnostics.

Requests and responses

The diagnostic tester initiates an exchange. The message header carries addressing information, and the payload carries a service identifier (SID) and any parameters. An ECU negative response begins with 0x7F, followed by the requested SID and a negative response code.

Example serviceRequest SIDPositive response SID
StartDiagnosticSession0x100x50
ReadECUIdentification0x1A0x5A
ReadDataByLocalIdentifier0x210x61

Related references

For the link between diagnostic requests and measurements, see Diagnostic communication protocols for serial logging. For diagnostics carried over CAN, see OBD-II and UDS diagnostic CAN IDs.

Source

ACTIA IME, KWP 2000 on K-Line (ISO 14230)