Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Speeduino & standalone tuning
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Changes from revision 1 to revision 1

Removed text is struck through; added text is highlighted.

This section brings together Speeduino and MegaSquirt hardware, software and tuning guidance. Both are programmable engine-management ecosystems, but Speeduino is a separate project, not a type of MegaSquirt. Some systems in each ecosystem use TunerStudio; shared software does not make their firmware, settings or wiring interchangeable.

Choose and identify an ECU

Speeduino hardware and board selection — generic shields, Dropbear, plug-in boards, third-party designs and selection checks.MegaSquirt and MicroSquirt: ECU families and identification — MS1, MS2, MS3, MicroSquirt, MS3Pro and plug-in variants.Browse the detailed Speeduino ECU family, PnPduino models and MegaSquirt and MS3Pro ECU family for individual products and documented wiring references.

Software and installation

TunerStudio, SpeedyLoader and MegaLogViewer guide — firmware, matching configuration definitions, tuning projects and logs.Speeduino first-start and installation guide — wiring checks, configuration, sensor calibration, trigger setup and initial start.

Tuning and troubleshooting

Standalone ECU fuel tuning guide — injector data, VE, lambda, warm-up and acceleration enrichment.Standalone ECU ignition and trigger setup — synchronisation, timing-light verification and ignition calibration.Standalone ECU datalogging and fault finding — capture and interpret logs and investigate common symptoms.

Always identify the precise ECU model, board revision, firmware and engine before using a wiring diagram or calibration. Capabilities and software settings vary; a base map is a starting point that needs verification. Refer to the Speeduino manual and MS/Extra manual index for the applicable hardware and firmware.

Rendered revisions

Open each version to inspect formatting, tables and photographs.

Revision 1: Speeduino and standalone ECU tuning: start here

This section brings together Speeduino and MegaSquirt hardware, software and tuning guidance. Both are programmable engine-management ecosystems, but Speeduino is a separate project, not a type of MegaSquirt. Some systems in each ecosystem use TunerStudio; shared software does not make their firmware, settings or wiring interchangeable.

Choose and identify an ECU

Software and installation

Tuning and troubleshooting

Always identify the precise ECU model, board revision, firmware and engine before using a wiring diagram or calibration. Capabilities and software settings vary; a base map is a starting point that needs verification. Refer to the Speeduino manual and MS/Extra manual index for the applicable hardware and firmware.

Revision 1: Speeduino and standalone ECU tuning: start here

This section brings together Speeduino and MegaSquirt hardware, software and tuning guidance. Both are programmable engine-management ecosystems, but Speeduino is a separate project, not a type of MegaSquirt. Some systems in each ecosystem use TunerStudio; shared software does not make their firmware, settings or wiring interchangeable.

Choose and identify an ECU

Software and installation

Tuning and troubleshooting

Always identify the precise ECU model, board revision, firmware and engine before using a wiring diagram or calibration. Capabilities and software settings vary; a base map is a starting point that needs verification. Refer to the Speeduino manual and MS/Extra manual index for the applicable hardware and firmware.