This section brings together Speeduino and MegaSquirt hardware, software and tuning guidance. Both are programmable engine-management ecosystems, but Speeduino is a separate project, not a type of MegaSquirt. Some systems in each ecosystem use TunerStudio; shared software does not make their firmware, settings or wiring interchangeable.
Choose and identify an ECU
- Speeduino hardware and board selection — generic shields, Dropbear, plug-in boards, third-party designs and selection checks.
- MegaSquirt and MicroSquirt: ECU families and identification — MS1, MS2, MS3, MicroSquirt, MS3Pro and plug-in variants.
- Browse the detailed Speeduino ECU family, PnPduino models and MegaSquirt and MS3Pro ECU family for individual products and documented wiring references.
Software and installation
- TunerStudio, SpeedyLoader and MegaLogViewer guide — firmware, matching configuration definitions, tuning projects and logs.
- Speeduino first-start and installation guide — wiring checks, configuration, sensor calibration, trigger setup and initial start.
Tuning and troubleshooting
- Standalone ECU fuel tuning guide — injector data, VE, lambda, warm-up and acceleration enrichment.
- Standalone ECU ignition and trigger setup — synchronisation, timing-light verification and ignition calibration.
- Standalone ECU datalogging and fault finding — capture and interpret logs and investigate common symptoms.
Always identify the precise ECU model, board revision, firmware and engine before using a wiring diagram or calibration. Capabilities and software settings vary; a base map is a starting point that needs verification. Refer to the Speeduino manual and MS/Extra manual index for the applicable hardware and firmware.