ThunderMax 309-362 is a vehicle-specific standalone replacement engine-management kit for fuel-injected Harley-Davidson motorcycles. It replaces the original ECM and connects to the specified vehicle harness; it is not simply a piggyback fuel controller. ThunderMax model documentation.

Application and identification
2008–2013 Harley-Davidson Touring and 2009–2013 Trike models with throttle-by-wire. Manufacturer source.
Check the part number, model year, throttle arrangement, vehicle equipment and the manufacturer’s current installation guide. Kit contents and engine compatibility must not be inferred from the common ThunderMax brand or another part number.
Control and installation
ThunderMax describes its replacement systems as using wideband oxygen-sensor feedback and AutoTune. Sensors, adapters, software, basemap and calibration depend on the kit and vehicle. Manufacturer system overview; installation and support documents.
Connector information
This application uses the relevant factory-style vehicle connection and the kit’s associated sensor harness. A complete pin-by-pin schedule for this exact part number has not been verified here; consult the matching installation instructions and identify the connector and harness before wiring. Do not transfer a pinout from another Harley-Davidson model or ThunderMax kit.
Factory throttle-by-wire circuits — partial vehicle-harness reference
Harley-Davidson’s technical tip TT418, dated 3 November 2009, hosted in ThunderMax’s document library, gives these factory ECM connector [78A]/[78B] throttle circuit positions for the Touring, Police and Trike applications in its scope. These are factory motorcycle harness references, not a complete ThunderMax 309-362 pinout; the bulletin does not establish every 2008–2013 model-year or aftermarket-ECM variation. Verify the exact motorcycle, connector view and applicable wiring diagram before use. Wire abbreviations follow the original bulletin.
| Factory ECM position | Harley-Davidson circuit | Factory wire label |
|---|---|---|
| 29 | Throttle-by-wire high | BK/O |
| 30 | Throttle-by-wire low | BK/PK |
| 36 | Throttle position sensor 2 | BN/R |
| 37 | Throttle position sensor 1 | BN/V |
| 39 | Twist-grip sensor 2 | V/Y |
| 50 | 5 V sensor power 1 | BN/O |
| 52 | Supply used by throttle actuator drive | YEL/GN |
| 59 | Twist-grip sensor 1 | BE/GN |
| 61 | 5 V sensor ground 1 | BK/W |
| 62 | 5 V sensor ground 2 | BK/GY |
| 68 | 5 V sensor power 2 (labelled “Gower-2” in figure) | R/W |