Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

ThunderMax 309-362 is a vehicle-specific standalone replacement engine-management kit for fuel-injected Harley-Davidson motorcycles. It replaces the original ECM and connects to the specified vehicle harness; it is not simply a piggyback fuel controller. ThunderMax model documentation.

Manufacturer illustration of the ThunderMax 309-362 kit
Manufacturer illustration of the ThunderMax 309-362 kit. Image: ThunderMax manufacturer product listing, reproduced with permission.

Application and identification

2008–2013 Harley-Davidson Touring and 2009–2013 Trike models with throttle-by-wire. Manufacturer source.

Check the part number, model year, throttle arrangement, vehicle equipment and the manufacturer’s current installation guide. Kit contents and engine compatibility must not be inferred from the common ThunderMax brand or another part number.

Control and installation

ThunderMax describes its replacement systems as using wideband oxygen-sensor feedback and AutoTune. Sensors, adapters, software, basemap and calibration depend on the kit and vehicle. Manufacturer system overview; installation and support documents.

Connector information

This application uses the relevant factory-style vehicle connection and the kit’s associated sensor harness. A complete pin-by-pin schedule for this exact part number has not been verified here; consult the matching installation instructions and identify the connector and harness before wiring. Do not transfer a pinout from another Harley-Davidson model or ThunderMax kit.

Factory throttle-by-wire circuits — partial vehicle-harness reference

Harley-Davidson’s technical tip TT418, dated 3 November 2009, hosted in ThunderMax’s document library, gives these factory ECM connector [78A]/[78B] throttle circuit positions for the Touring, Police and Trike applications in its scope. These are factory motorcycle harness references, not a complete ThunderMax 309-362 pinout; the bulletin does not establish every 2008–2013 model-year or aftermarket-ECM variation. Verify the exact motorcycle, connector view and applicable wiring diagram before use. Wire abbreviations follow the original bulletin.

Factory ECM positionHarley-Davidson circuitFactory wire label
29Throttle-by-wire highBK/O
30Throttle-by-wire lowBK/PK
36Throttle position sensor 2BN/R
37Throttle position sensor 1BN/V
39Twist-grip sensor 2V/Y
505 V sensor power 1BN/O
52Supply used by throttle actuator driveYEL/GN
59Twist-grip sensor 1BE/GN
615 V sensor ground 1BK/W
625 V sensor ground 2BK/GY
685 V sensor power 2 (labelled “Gower-2” in figure)R/W