Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
Holley Sniper EFI
Applies to
Holley Sniper EFI
Tool groups
None
Manufacturers
None

Holley Super Sniper EFI 2300 is a carburettor-replacement throttle-body fuel-injection system with integrated electronic control. The handheld is a setup/display device, and the system also requires appropriate fuel delivery, wiring and sensors.

Holley Super Sniper EFI 2300 throttle-body EFI
Holley Holley Super Sniper EFI 2300 family illustration from its installation manual, cover; finish and injector count vary with part number. Manufacturer photograph reproduced with permission.

Applications and versions

Designed for a Holley 2300-style two-barrel intake flange. Holley lists the four-injector Super Sniper for boosted applications; select injectors, calibration and fuel delivery for the engine.

Four injectors with boost-control provisions and an integrated ECU. The 550-852, 550-853 and 550-854 are listed as finish variants; it differs from the two-injector 2300. Model numbers: 550-852 / 550-853 / 550-854. See Holley’s Sniper model comparison.

Manufacturer harness connections

The model-specific Holley installation manual, PDF page 18, identifies the seven-way 558-490 main harness and ten-way 558-491 I/O harness below. The ten-way table has eight populated wires; the source does not assign the remaining two cavities. Outputs are relay-control signals: use the source for ratings, ignition configuration and the connector view. The throttle body, 4-pin CAN handheld connection, coolant sensor and oxygen sensor are separate connections.

Seven-way main harness, 558-490

PinWire colourManufacturer function
AVioletCrank signal positive
BDark greenCrank signal negative
CBlueFuel-pump supply from relay
DYellowCoil-negative engine-speed input
ERedBattery positive
FPinkSwitched ignition +12 V
GBlackBattery negative

Ten-way I/O harness, 558-491

PinWire colourManufacturer function
AOrangeInput 1, ground-triggered A/C
BYellowInput 2, programmable ground input
CLight blueOutput 1, fan 1 relay trigger
DLight greenOutput 2, fan 2 relay trigger
EGreyOutput 6, A/C shutdown relay trigger
FWhitePoints output for compatible ignition
GDark brownTachometer output
HTanDigital gauge output

Eight-way auxiliary I/O harness, 558-492

Optional harness for this Super Sniper or Stealth application.

PinWire colourManufacturer function
AOrangeSensor reference +5 V
BBlackSensor ground
CVioletInput 3, 0–5 V
DPinkInput 4, 0–5 V
EDark greenInput 5, 0–5 V
FDark blueOutput 3, ground-switched
GDark brownOutput 4, ground-switched
HGreyOutput 5, ground-switched

Installation and ignition

The correct fuel pump, filters, sensor placement and ignition setup depend on the kit and vehicle. An RPM input alone does not establish ECU timing control; consult the manual and identify the ignition hardware before wiring.