Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

Holley Super Sniper EFI 2300 is a carburettor-replacement throttle-body fuel-injection system with integrated electronic control. The handheld is a setup/display device, and the system also requires appropriate fuel delivery, wiring and sensors.

Holley Super Sniper EFI 2300 throttle-body EFI
Holley Holley Super Sniper EFI 2300 family illustration from its installation manual, cover; finish and injector count vary with part number. Manufacturer photograph reproduced with permission.

Applications and versions

Designed for a Holley 2300-style two-barrel intake flange. Holley lists the four-injector Super Sniper for boosted applications; select injectors, calibration and fuel delivery for the engine.

Four injectors with boost-control provisions and an integrated ECU. The 550-852, 550-853 and 550-854 are listed as finish variants; it differs from the two-injector 2300. Model numbers: 550-852 / 550-853 / 550-854. See Holley’s Sniper model comparison.

Manufacturer harness connections

The model-specific Holley installation manual, PDF page 18, identifies the seven-way 558-490 main harness and ten-way 558-491 I/O harness below. The ten-way table has eight populated wires; the source does not assign the remaining two cavities. Outputs are relay-control signals: use the source for ratings, ignition configuration and the connector view. The throttle body, 4-pin CAN handheld connection, coolant sensor and oxygen sensor are separate connections.

Seven-way main harness, 558-490

PinWire colourManufacturer function
AVioletCrank signal positive
BDark greenCrank signal negative
CBlueFuel-pump supply from relay
DYellowCoil-negative engine-speed input
ERedBattery positive
FPinkSwitched ignition +12 V
GBlackBattery negative

Ten-way I/O harness, 558-491

PinWire colourManufacturer function
AOrangeInput 1, ground-triggered A/C
BYellowInput 2, programmable ground input
CLight blueOutput 1, fan 1 relay trigger
DLight greenOutput 2, fan 2 relay trigger
EGreyOutput 6, A/C shutdown relay trigger
FWhitePoints output for compatible ignition
GDark brownTachometer output
HTanDigital gauge output

Eight-way auxiliary I/O harness, 558-492

Optional harness for this Super Sniper or Stealth application.

PinWire colourManufacturer function
AOrangeSensor reference +5 V
BBlackSensor ground
CVioletInput 3, 0–5 V
DPinkInput 4, 0–5 V
EDark greenInput 5, 0–5 V
FDark blueOutput 3, ground-switched
GDark brownOutput 4, ground-switched
HGreyOutput 5, ground-switched

Installation and ignition

The correct fuel pump, filters, sensor placement and ignition setup depend on the kit and vehicle. An RPM input alone does not establish ECU timing control; consult the manual and identify the ignition hardware before wiring.