Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
ABS / DSC
Parent
Davis Technologies TMS Drag Lite MAP
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Davis Technologies

These allocations are from the Davis Technologies TMS-Drag-Lite-MAP manual, printed pages 8–9. The power, sensor and output plugs are separate connectors; both three-pin plugs use A/B/C but have different functions. Do not transfer this to other TMS or TC-3 hardware.

Two-pin power input

TerminalWireFunction
ARed12 V positive
BBlack12 V ground

Three-pin driveshaft sensor connector

TerminalWireFunction
ARedSensor positive, 12 V
BBlackSensor ground
CWhiteSensor signal wire

The manual scopes these colours to Davis-supplied sensors and asks users to check other sensors with their maker. Connector lettering is specific to this plug.

Three-pin output connector

TerminalWireFunction
AGreenMAP signal to ignition controller
BBlackMAP ground to ignition controller
CPinkCorrection indication, +12 V output through a 1 kilohm resistor

The manual separately labels the mating ignition MAP sensor plug A as ground and B as signal, the reverse letter mapping from this output plug. Identify each connector before use. Davis Technologies TMS-Drag-Lite-MAP manual, pages 8–9.