Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Engine ECU
Parent
PnPduino standalone ECUs
Applies to
PnPduino standalone ECUs
Tool groups
None
Manufacturers
None

PnPduino Toyota 1FZ-FE Gen2 is a PnPduino programmable engine-management ECU. Manufacturer product information.

PnPduino Toyota 1FZ-FE Gen2
PnPduino Toyota 1FZ-FE Gen2. PnPduino manufacturer product photograph, reproduced with permission.

Application and identification

Plug-in for the manufacturer's 1998–2002 4.5-litre Toyota Land Cruiser 1FZ-FE Gen2 application, manual transmission only. It uses three vehicle plugs of 26, 16 and 22 positions. The supplier explicitly says Gen2 and Gen3 pinouts differ and must not be interchanged.

System and wiring

A VR conditioner is fitted. The manufacturer describes semi-sequential injection and wasted-spark ignition, stock MAP sensing, and high- or low-impedance injector support. An aftermarket wideband controller is required for proper tuning.

Connector identification

ConnectorManufacturer descriptionScope
Vehicle connector 126 positionsSee manufacturer for matching Gen2 cavity assignments
Vehicle connector 216 positionsSee manufacturer for matching Gen2 cavity assignments
Vehicle connector 322 positionsSee manufacturer for matching Gen2 cavity assignments

A complete pin-by-pin ECU connector table has not been verified from the cited product information. Obtain the diagram for the exact model and revision from PnPduino documentation; the vehicle ECU pinout and other PnPduino models must not be assumed interchangeable.

Software and calibration

This listing specifies official Speeduino firmware and use of the SpeedyLoader INI; check the actual build and manufacturer guidance. A supplied base map needs final tuning.

See the PnPduino manufacturer index.