Tokyo Plant supplies dynamometers, test-bed equipment and control systems. Its documented DY-1000T is a control and measurement unit for an eddy-current dynamometer. It combines speed and torque measurement, manual or automatic control and alarm monitoring for an engineered test installation. Tokyo Plant DY-1000T product information and photograph.
DY-1000T: operating principle
In a speed-hold test, the controller compares measured speed with a requested value and changes the eddy-current absorber demand to oppose the test machine. In torque mode, it uses the system's torque measurement as feedback. Tokyo Plant describes digital PID control, speed and torque displays, an alarm display, rotary control and operation with a higher-level external system. Exact sensors, brake driver, wiring and control strategy depend on the installation. Manufacturer specification.
The generic schematic above explains the feedback concept; it is not a DY-1000T wiring or safety diagram. An eddy-current absorber cannot supply motoring capability merely because its controller uses electrical power. The brake's torque–speed and cooling limits remain in force.
Modes and interfaces
- Manual: operator command via the panel's manual control.
- Constant speed: feedback adjusts dyno loading to a speed target within the installed machine's envelope.
- Constant torque: feedback regulates measured torque to a target where a suitable operating point exists.
- External automation: the product page describes programmed operation by a higher-level system and analogue 0–10 V I/O.
The published specification lists emergency-stop, overspeed, over-torque, outlet-water-temperature, bearing-temperature and external-contact alarm functions for the described configuration. The page lists a 200 V three-phase 50/60 Hz supply; verify the actual nameplate, electrical standard, alarm configuration and applicable documentation before specifying equipment for another location. The maker says model details may change.
Compatible dynos and brakes
Tokyo Plant identifies the DY-1000T specifically for an eddy-current dynamometer and describes expansion to an existing test system. The documentation does not establish a universal retrofit for every brand, chassis dynamometer or hub dyno. Ask the supplier to match the specific brake, field supply, torque and speed sensors, cooling monitoring, control interface and interlocks. Do not assume its 0–10 V signal or a physically similar connector is interchangeable with another brake power stage.
Tokyo Plant also lists hydraulic and other test controllers separately; their capabilities and model numbers must not be attributed to DY-1000T. Its controller product index provides model-family context. For broader comparison see Dynamometer control systems and factory and aftermarket controller comparison.