MoTeC SDC part 14009, 40-pin connector. This partial table is based on the manufacturer’s SDC manual dated 22 February 2008, Appendix B, and its SDC support article. It is not an SDC2 or SDC3 pinout. Check the connector orientation and exact unit with MoTeC.
| Pin | Function |
|---|---|
| 1 | Diff mode 3 dash light output, active low |
| 2 | Diff mode 2 dash light output, active low |
| 3 | Diff mode 1 dash light output, active low |
| 4 | Diff open dash light output, active low |
| 7 | Rear diff temperature input, low when hot |
| 8 | Auto/manual switch input, future use |
| 9 | Brake pedal input, battery voltage when applied |
| 11 | Handbrake input, low when on |
| 12 | Thumbwheel input |
| 13 | 5 V output for thumbwheel and G sensor |
| 14 | No connection |
| 15 | Battery positive, electronics |
| 16 | Battery positive, electronics |
| 17 | No connection |
| 18 | Differential solenoid power input |
| 19 | Differential solenoid power input |
| 20 | Differential drive positive output |
| 21 | Differential relay control output |
| 22 | No connection |
| 23 | Differential locked dash light output, active low |
| 24 | Diff mode 4 dash light output, active low |
| 25 | No connection |
| 26 | Rear left wheel speed input |
| 27 | Rear right wheel speed input |
| 28 | Front left wheel speed input |
| 29 | Front right wheel speed input |
| 30 | No connection |
| 31 | Tacho input, 2 pulses per engine revolution |
| 32 | Throttle position sensor input |
| 33 | Lateral G input |
| 34 | 0 V to thumbwheel and G sensor |
| 35 | No connection |
| 36 | Battery negative, electronics ground |
| 37 | Battery negative, electronics ground |
| 38 | Differential solenoid ground input |
| 39 | Differential solenoid ground input |
| 40 | Differential solenoid negative output, switched |
Conflicting or configuration-dependent positions
Pins 5 and 6 are deliberately not assigned here: the MoTeC SDC manual lists pin 5 as CAN low and pin 6 as CAN high in its connector and communications tables, but its link table reverses those labels. The online support article also has inconsistent link labels. Confirm the actual controller and board links with MoTeC before connecting CAN.
Pin 10 is omitted because it is configuration-dependent and the manufacturer documents use inconsistent internal-link identifiers for its ABS-input or sensor-ground selection. Consult MoTeC for the exact board revision. Do not infer an assignment from a different SDC model.
Sources: MoTeC SDC manual, Appendix B and Appendix E; MoTeC SDC support article.