Tuning Wiki
Browse MoTeC Subaru

MoTeC SDC part 14009, 40-pin connector. This partial table is based on the manufacturer’s SDC manual dated 22 February 2008, Appendix B, and its SDC support article. It is not an SDC2 or SDC3 pinout. Check the connector orientation and exact unit with MoTeC.

PinFunction
1Diff mode 3 dash light output, active low
2Diff mode 2 dash light output, active low
3Diff mode 1 dash light output, active low
4Diff open dash light output, active low
7Rear diff temperature input, low when hot
8Auto/manual switch input, future use
9Brake pedal input, battery voltage (12 V) when applied
11Handbrake input, low when on
12Thumbwheel input
135 V output for thumbwheel and G sensor
14No connection
15Battery positive, electronics
16Battery positive, electronics
17No connection
18Differential solenoid power input
19Differential solenoid power input
20Differential drive positive output
21Differential relay control output
22No connection
23Differential locked dash light output, active low
24Diff mode 4 dash light output, active low
25No connection
26Rear left wheel speed input
27Rear right wheel speed input
28Front left wheel speed input
29Front right wheel speed input
30No connection
31Tacho input from ECU, 2 pulses per engine revolution
32Throttle position sensor input
33Lateral G input
340 V to thumbwheel and G sensor
35No connection
36Battery negative, electronics ground
37Battery negative, electronics ground
38Differential solenoid ground input
39Differential solenoid ground input
40Differential solenoid negative output, switched

Conflicting or configuration-dependent positions

Pins 5 and 6 are deliberately not assigned here: the MoTeC SDC manual lists pin 5 as CAN low and pin 6 as CAN high in its connector and communications tables, but its link table reverses those labels. The online support article also has inconsistent link labels. Confirm the actual controller and board links with MoTeC before connecting CAN.

Pin 10 is omitted because it is configuration-dependent and the manufacturer documents use inconsistent internal-link identifiers for its ABS-input or sensor-ground selection. Consult MoTeC for the exact board revision. Do not infer an assignment from a different SDC model.

Sources: MoTeC SDC manual, Appendix B and Appendix E; MoTeC SDC support article.