Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
ABS / DSC
Parent
Bosch Motorsport ABS M5
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Bosch

Selected 38-position ABS M5 ECU assignments from Bosch Motorsport’s basic ABS M5 diagram F02U.S02.XXX-01 in its M5 kit manual, printed page 52. The drawing contrasts option 1 (direct sensors with ECU TTL wheel-speed outputs) and option 2 (wheel-speed interface). The TTL outputs below are shown for option 1 only. This is not a generic M4 or road ABS pinout; other positions are not specified here. WS and WP and black/white descriptions follow the diagram, without assuming sensor polarity. Identify actual connector orientation and kit configuration from Bosch documentation.

ECU pinFunction in the cited diagram
1VBat motor relay; S1 fuse 40 A
2Front right wheel-speed TTL output, option 1
4WS front right, black
5V_Stab +5 V
7Analog 2
8WS front left, black
10ABS warning lamp
12Rear right wheel-speed TTL output, option 1
13Motor ground
14CAN low
16WP front right, white
17WP rear right, white
18WS rear left, black
19WP front left, white
20CAN2 low
21Digital 1
22Analog 1
23Front left wheel-speed TTL output, option 1
25VBat valve relay; S2 fuse 25 A
26CAN high
28KL15 switched supply; S3 fuse 10 A
29WS rear right, black
31WP rear left, white
32A_GND for pressure sensors
33CAN2 high
34Rear left wheel-speed TTL output, option 1
36Front brake-pressure sensor signal
37Rear brake-pressure sensor signal
38Valve ground

Source: Bosch Motorsport ABS M5 kit manual, section 14.7, page 52, and harness options. The manual includes a separate Clubsport wiring diagram; verify that and the exact supplied harness rather than assuming all variants are the same. Bosch warns M4 and M5 looms are not interchangeable.