Selected 38-position ABS M5 ECU assignments from Bosch Motorsport’s basic ABS M5 diagram F02U.S02.XXX-01 in its M5 kit manual, printed page 52. The drawing contrasts option 1 (direct sensors with ECU TTL wheel-speed outputs) and option 2 (wheel-speed interface). The TTL outputs below are shown for option 1 only. This is not a generic M4 or road ABS pinout; other positions are not specified here. WS and WP and black/white descriptions follow the diagram, without assuming sensor polarity. Identify actual connector orientation and kit configuration from Bosch documentation.
| ECU pin | Function in the cited diagram |
|---|---|
| 1 | VBat motor relay; S1 fuse 40 A |
| 2 | Front right wheel-speed TTL output, option 1 |
| 4 | WS front right, black |
| 5 | V_Stab +5 V |
| 7 | Analog 2 |
| 8 | WS front left, black |
| 10 | ABS warning lamp |
| 12 | Rear right wheel-speed TTL output, option 1 |
| 13 | Motor ground |
| 14 | CAN low |
| 16 | WP front right, white |
| 17 | WP rear right, white |
| 18 | WS rear left, black |
| 19 | WP front left, white |
| 20 | CAN2 low |
| 21 | Digital 1 |
| 22 | Analog 1 |
| 23 | Front left wheel-speed TTL output, option 1 |
| 25 | VBat valve relay; S2 fuse 25 A |
| 26 | CAN high |
| 28 | KL15 switched supply; S3 fuse 10 A |
| 29 | WS rear right, black |
| 31 | WP rear left, white |
| 32 | A_GND for pressure sensors |
| 33 | CAN2 high |
| 34 | Rear left wheel-speed TTL output, option 1 |
| 36 | Front brake-pressure sensor signal |
| 37 | Rear brake-pressure sensor signal |
| 38 | Valve ground |
Source: Bosch Motorsport ABS M5 kit manual, section 14.7, page 52, and harness options. The manual includes a separate Clubsport wiring diagram; verify that and the exact supplied harness rather than assuming all variants are the same. Bosch warns M4 and M5 looms are not interchangeable.